0
Motor on 1997 ford aerostar 3.0 sounds like its missing and running rough?
Wiki User
∙ 15y ago
I would suggest you replace the Spark Plugs and Plug wires on a 11 year old vehicle. If it is still missing, then remove all spark plugs an run a compression test. If it is loosing collant with no apparent leak, and has low compression on one or two cylinders suspect a blown head gasket.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
You were driving your aerostar van and it just stopped going the motor kept running but it would go any where?
either out of trans. oil , or tranmission is shot
How do you change the power window motor on the 1993 aerostar?
how do you change a window motor on a 93 aerostar or can you please tell me how to get the windows down without the motor... my e-mail is snakespittbulls@yahoo.com
Is the 3.0 1989 aerostar motor cast iron?
Yes
What type of motor oil for 3.0 ford aerostar?
10w30
Where is the heat sensor located on the motor?
motor heat sensor where is it locasted in a 1996 aerostar ford van
Does a 1991 ford aerostar 3.0 have a timing chain in its motor?
yes it does!
What are the cylinder positions on a 3 L motor on a 1993 Ford Aerostar?
On a 1993 Ford Aerostar 3.0 ( and 4.0 ) 3 - 6 2 - 5 1 - 4 front of Ford Aerostar
How many Ford Aerostar were produced in total?
The Ford Aerostar is a van that was produced from 1986 to 1997 by the Ford Motor Company. They produced 2,029,577 Aerostar vans in that time. This model was replaced by the Ford Windstar.
How do you jumper the window switch to get the window to come go up on a 1991 Ford Aerostar?
If you press the switch and hear the motor running, the the gear kit needs to be replaced. If you do not hear it, look at the dome light and see if it dims when you press the switch. If it does then you have a bad motor.
Where are the freeze plugs on a 92 Aerostar XL?
Near where the motor and transmission connect
How can you tell what size motor is in your 92 aerostar?
Decode the 8th digit in the VIN.
Why is your 2004 Dodge Stratus air conditioner running only on high?
sounds like the blower motor resistor is out on the lower speeds.
