0
move
ig aaron2raw
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
By releasing the brake the car was put into motion?
Move A+
What force opposes the motion of your car when your step on the brake pedal?
Friction.
Why do passengers in a car fly forward when the car comes to a sudden stop?
When the car vis moving u are at the same pace with but a sudden brake stops the motion of the car but not yours An object in motion tends to stay in motion.
What sort of energy do the brakes produce when the car is in motion?
When the brakes are applied, the car's kinetic energy is converted to heat by friction between the brake pad and the brake disk.
Why would the emergency brake light in a 1999 Mercury Villager stay on after releasing the brake?
It can be the turn signal switch. Two possibilities. one: there is a switch that when depressed turns on the light, it could be stuck. I haven't looked for one on this car. two: your brake is not fully releasing as cable has gotten rusty. Look under car and see if you can give it a yank and it releases.
When you reverse the car locks up?
it sounds to me that your hand brake is applied or stuck on.try releasing it or check the rear brakes.
How do you bleed brakes on 95 town car?
put brake fluid in reservoir and loosen the bleeder screws. step on the brake with the motor running and tighten bleeders before releasing brake pedal. repeat as needed
Why does a car make a clunking sound after releasing the brake but before accelerating?
sounds like your brake calipers could be sticking.after a short run feel your rim if it seems overly hot that's probaly what it is
What are the purpose of brake?
A 'brake' is a device on a vehicle or machine to stop it's motion. On a car or truck, a brake is typically attached to each wheel and mechanically clamps a disc or rotor to stop the wheel turning.
What causes lights to blink on and off in your car?
The flasher unit for the indicators. Pressing and releasing the foot brake for the brake lights. Turning the light switch on and of for the others. If it is not any of these then there is an electrical fault, possibly a loose connection.
What is the name of the small rubber piece that is located under the brake pedal that turns off the tail lights?
The part of the car that turns on the brake lights when you apply pressure to the brake pedal is called the brake switch. Releasing pressure from the pedal causes the brake switch to break its electrical contact, turning off the lights.
The emergency brake on your 1992 cutlass sounds like it is releasing when you pull the release knob but the car still wont move when you put it in drive but it goes in reverse What could be wrong?
parking brake cable may be sticking.
