look for clogged ex.
A CKP is the crankshaft position sensor. The engine computer uses that sensor to know the position of the crankshaft for fuel and ignition timing purposes. With out the ckp the engine will not run.
There is a crankshaft position sensor , at the front of the engine
where is the cam shaft position sensor on a 98 ford explorer 4x4 4.0 sohc 4x4
The throttle position sensor is mounted on the side of the throttle body
YES - it has a camshaft position sensor
The crankshaft sensor is critical to the operation of the engine as it supplies information to the engine management computer. It senses both crankshaft position and engine RPM. If the sensor is defective, or improperly adjusted, then the computer cannot receive the proper signals, and can't keep the engine running.
a pintle position sensor tell the engine computer what the exact position of the egr valve is
there is no need to reset the computer for an 02 sensor.
The crankshaft position sensor is located on the front of the engine. It is just to the left of the crankshaft pulley.
According to my Chilton repair manual , the crankshaft position sensor is used to determine crankshaft position and crankshaft RPM
Accelerator Pedal Position Sensor It's a sensor on your accerlerator that works in concert with the throttle position sensor and vehicle's computer to accelerate the vehicle.
The crankshaft position sensor measures the rotational position of the crankshaft for the engine computer. That info is required for fuel and ignition timing.The crankshaft position sensor measures the rotational position of the crankshaft for the engine computer. That info is required for fuel and ignition timing.