There is a crankshaft position sensor , at the front of the engine
how do you replace the overdrive sensor on a 94 ford explorer
I don't believe a 1994 Ford Explorer has a knock sensor - OBD I / EEC IV system
It is in the differential and secured by a 10mm bolt.
On a 1994 Ford Explorer : The Mass Air Flow sensor is located between the top section of the engine air filter housing and the engine air intake tube
As far as I know , the 1994 Ford Explorer - 4.0 L - OHV engine does not have a knock sensor ( in 1996 when Ford went to OBD II / EEC - V the knock sensor was added on the 4.0 L - OHV engine )
Ford did not start using knock sensors on the Ford Explorer engines until 1996, when they switched to the EEC-V system.
Is there a fuse I can remove for the ford explorer tire sensor
Where are the Bank 1 Sensor 1 oxygen sensor on a 1998 ford explorer?
how do i change a fuel filter in a 1994 ford explorer
The crankshaft position sensor is mounted on the front of the engine, just to the left of the crankshaft pulley ( when you are looking from the front of the Explorer. Helpfull
Yes! The 1991-1994 Ford Explorer transmissions are interchangeable.
On your 1994 Ford Explorer , I believe the intake air temperature sensor is mounted in the side of your upper intake manifold , not too far from the idle air control valve , as you look along the side of the upper intake manifold towards the firewall (Helpfull)