Second opinion: I have a 2000 P M with same problem & the Chevy dealer told me it could not be replaced. He said they replace the radio.
Ye! Sux I know!
I have a 1998 Pontiac GT and the light was burned out on the display. Could not find one at the dealership. The place i found one was www.corvetteradios.com. Hope this helps. I had that problem on my GP GT ´97, I pulled out the radio and there´s a small light behind the dispaly, it was burned, I had to replace it. You can buy it in radioshack, you need to weld it.
if you are referring to the stock radio... i think you have to take off the front part of the radio... if its possible at all to replace them ==Another answer== I just pulled the front off a spare stock Delco radio from my '96 (a few plastic clips around the perimeter let it come out) There is one obvious bulb behind what would be the station/time display. Getting to it is a mystery as it's behind a plastic shield that appears to be fastened to the PC board. The lights behind the pre-set buttons are not obvious because there is a PC board right behind the front panel of the radio. If I recall correctly, I replaced this radio because A. the station/clock display didn't work, and B. because either the pre-set buttons didn't light up, or maybe just because the plastic coating over them was damaged. I found a used perfectly working replacement on Ebay for about $30.
I heard it was meant to look like a security system.
Replace the radio.
remove the whole console that goes around your radio and down to the ashtray. 2 screws up top and 2 down below. be carefull because the plastic is not to strong. but when you get it out you will see it at the bottom behind the ashtray... spiked2u@aol.com
To replace the brake light on a 2000 Pontiac Montana open the trunk to reveal the housing units. Find the lights and pull the bulbs out. Replace the units.
its behind the driver side head light. take the head light out and u will see the horn.
Have you tried looking behind the center vents above the stereo?
ther might be a replacable circuit board of some kind behind the tail light housing
In order to change the brake light, check your manual for directions. You will need to remove the cover and replace the burnt out bulb.
how to replace map light bulb in a 2006 pontiac torrent
It is a Pontiac Aztek. Light a match and get some marshmallows.
take bulb out from behind light assembly, under hood. look for wires that is connected to light, this is where the bulb comes out.
IT is in the sun
i had the same problem. you need to replace the switch behind the hazard light button and that will solve the problem.
how do you replace license pate light on 2006 pontia g6
I had the same problem. I took it in for an inspection, and the mechanic told me that the right frontseat belt assembly needed to be replaced. It cost about $114 to replace, but the light has not been on since then. This is something that you may want to check