Timing and Firing Orders
Dodge Ram
Chevy 350
Need for Speed

Need ignition timing and idle speed specs for a 1990 Chevrolet K2500 truck 350 K series ac 4wd?

202122

Top Answer
User Avatar
Wiki User
2008-08-14 03:22:24
2008-08-14 03:22:24

autozone.com has online manuals that give you all that info Also just look under the hood. There you will find a placard with this some if not all this information.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

That requires an OBDII engine scanner to set the timing to factory specs.

User Avatar

It is a 3/4 ton 4 wheel drive.

User Avatar

Chevrolet K series answer C designates 2WD as in C1500 = 2WD 1/2 ton K designates 4WD as in K2500 = 4WD 3/4 ton -tweek

User Avatar

That requires an OBDII engine scanner. the timing is electronic controled. You can NOT use a timing light.

User Avatar

Its on the front of the crankshaft in front of the timing chain.

User Avatar

The 1998 Chevrolet K2500 Suburban is able to tow up to 6,000 pounds. Standard features include power steering, and tinted glass.

User Avatar

The fuel pump is located inside the gas tank on a 1993 Chevrolet K2500. To access it the tank will have to be removed. The relay is easier to access and is found under the driver side dashboard.

User Avatar

The 1998 K2500 Suburban has a 44 gallon gas tank.

User Avatar

yes and should have a relay too in the under hood fuse box

User Avatar

When you open the bonnet, you will see it on top left hand side of the the engine.

User Avatar

it's underneath the rotor in the distributor. you have to take the distributor out to change it.

User Avatar

Honestly if you don't know where the drain plug is, don't mess with the vehicle then!

User Avatar

start at 7 or 8 and for every 1000 feet over sea level go up another degree like at 5000 feet over sea level it should be around 12 or 13

User Avatar

The size of the gas tank on 2000 Chevy k 2500 is twenty five gallons. This is for a V8 5.7 L.

User Avatar

It is bolted in the transfur case tail shaft housing with 1 bolt and has an electric wire connected to it.

User Avatar

If it is the same as my 1995 k2500 it is a single tan wire with a black stripe underneath the glove box inside the cab.

User Avatar

you can if your tires arent sticking out the side of the truck. its illegal if they stick out. and it depends if you have a body kit.

User Avatar

If you look at the bumber real close where the ball goes it will be written on it.

User Avatar

According to IntelliChoice (see links), the curb weight of a 1991 Chevrolet Suburban K2500 is 4,540 pounds. The gross vehicle weight is 8,600 lbs.

User Avatar

Shift it into either 4H or 4L, and sometimes, after going into 4X4, you need to put the car in reverse for a few feet to engage it.

User Avatar

I've reading alot on this latley, and seem to be having the same problem. I believe it can. I am going to replace my ignition control module tonight and see if my injectors then start working on my K2500 7.4

User Avatar

To remove the door panel you will need to find and remove all screws. Once you have taken out the screws you will need to gently pull the panel away from the door.

User Avatar

2wd Suburbans came with a 28 gallon fuel tank, 4wd versions came with a 42 gallon tank.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.