there are not a lot of hoses, you have one from the fuel pump under the tank to the carb and one from the fuel pump to the intake for vacuum, there is also one from the air box to the valve cover for ventilation.
the bottom of the fuel pump is what connects to the carb, the side is for vacuum.
If your moped's maximum speed is 30 mph, yes, you will need to complete a training course, and obtain a class M2 license. No license and no training course are required if the moped's maximum speed is 20 mph. See the site referenced below.
If you lost the key to your moped you will have to contact the manufacturer of the moped to get another key. You can try going to a mechanics shop and see if they have the capabilities of making a new key.
I need a diagram for the 1991 Chevy blazer to see where the 3 hoses go to coming off the transfer case.
you have to disconnect the hoses first that are on the firewall it is best to go at it from under the car. Then after you have disconnected the hoses you need to remove both panels under the dash and you will see it from there as it is step by step
first you need to lift the hood and remove the two hoses from the back of the fire wall where the hoses are located. after you need to look under the dash board inside the car and remove all the screws and cover and then you will see the heater core. And the reverse will be the same. It will take a couple of hours no more than 3 hrs.
You can drive a moped at the age of 14. The age for a moped in the U.K. is 16. Spain and Italy is 14
First you need to make sure it is actually not heating up. Do this by checking to see if the radiator hoses are getting warm after running for 10-15 min. Be careful they could be HOT. If the hoses are hot then the heater core is plugged and will need to be replaced. If hoses do in fact not get hot then the thermostat is most likely stuck open. removing it will tell the tale.
Radiator hoses are located on almost all cars in front of the engine block. One hose on top and on on the bottom. Open your hood and look between the top of the headlights, you should see the first one next to the radiator cap. The bottom one you can see under the car, behind the bumper. They are the largest hoses under the hood.
see if it has a screw at the bottom of the float bowl, if so unscrew it and all the gas/water will drain out the vacuum hoses
left side back under a couple of hoses, need to really get under the hood to see it.
check the vaccums lines like the PVC valve to see if the hoses are cracked and need to be replaced or not.
It doesn't really matter as long as the moped has headlamps, tail lights, break lights, turn signals, mirrors, and license plates. Check with your local law enforcement to see if i missed anything.