Which filter housing? Air filter, oil filter, fuel filter?
check that the O ring was replaced when oil filter was changed. id O ring is good and filter is tight, and housing still leaking, replace filter housing
Here are a few reasons for oil to spray from the filter area:The gasket from the old filter was stuck on the oil filter housing and was not removed before the new filter was installed.The new filters gasket is not seated correctly on the oil filter housing.No Oil filter gasket was installed with the new oil filter.Defective Oil Filter and/or Gasket.Oil Filter Housing came lose from the engine block or mounting surface.
inside the oil filter housing
The filter is in a filter housing. Remove the plug in the bottom of the housing. The filter housing is then loosened using a specific wrench for that housing type.
take the filter off then unscrew the bolt at the oil filter housing
my oil filter housing is leaking what should i do?
depending on your vehicle, the housing is whear your oil filter screws into. remove oil filter and thi should reveal 3 or 4 bolts in the side of housing remove bolts should come off no problems replace seal behind housing reverse process
Right above the oil filter on the oil filter housing.
It is called the oil filter housing.
The oil filter housing is located on the front of the engine cases. It has a single bolt that attaches the housing to the engine. The housing itself is finned for cooling.
its in the oil filter housing
ON THE OIL FILTER HOUSING
oil filter is located under hood behind the air filter housing.
Under the air filter housing om the right side if the motor. It has to be serviced from the top. Pull your filter first or the filter housing will not drain when you pul;l the oil pan plug
oil filter housing
Its on the oil filter adapter housing and hard to get to.
It is near the oil filter adapter housing.
its located on the oil filter housing....
around the oil filter housing.
If you are talking about a hole in the oil filter housing, that would be for the oil pressure sending unit.
You must hand tighten the filter.
In the filter housing, d/s front of the engine, need a (12-14?) fluted oil filter socket
you drop the bottom fairing, exposing oil filter, using oil filter strap or pliers take off the old filter. wipe clean oil filter housing, lube gasket on new filter with new oil, spin on new filter, and tighten.