answersLogoWhite

0


Best Answer

Is it real cold were your at????? If so then replace the starter, The reason being is that the starter drive- ( bendix ) is kicking out as soon as it touches the fly-wheel and it just makes a werd noise. REPLACE STARTER.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: On Chevy Suburban 1999 starter is turning but the engine doesn't catch When started though the engine runs smooth and nice Can it be timing or what else?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Can you put an auto starter on an 86 suburban with a 454?

yes if it has fuel injection and auto trans, if it doesnt have either one, then no.


On a 1994 Isuzu Amigo SOMETIMES when i turn my key to start it doesnt do anything i have to keep turning key off and keep trying and finally it will start...What causes that?

Either the starter, starter relay or ignition switch are failing.


Where is the starter located in a 99 camaro and how do you tell if the starter is the reason it won't start?

well i dont know exactly where the starter is but you should be able to see it under the car around where the tranny bellhousing meets the engine at the fly wheel(auto) or flex plate(manual) either on the left or right side. if the car is not turning over at all then you can put a jumper from the battery to the starter solenoid and that should kick the starter on if it doesnt then you starter/solenoid is bad. but if you car turns over but doesnt start then your starter is fine.


How do you know the starter is bad in a Honda civic?

usually you can tell when your car doesnt turn or or doesnt turn over its because of your starter sometimes its not the starter it could be a low battery or corroded wires leading to the starter check that first;


3 starters installed on Daewoo Lanos all turn but motor doesn't crank?

starters turn but doesnt crank? If the starters are turning and engaging they will at leat be turning the flywheel, unless there is tooth damage. try to rock the vehicle in gear to test. look at bottom pulley (where the belts are) to see if crank is turning, both when starter is turned and when rocked in gear, this will at least tell you that the flywheel is attached to the crankshaft, and if it turns off the starter motor it also shows the starter motor is working correctly. If this is turning via the starter motor the next thing i would check it the timing/cam belt. behind the plastic cover behind all the belts, especially if the engine is turning fast, wirring and not making the usual chug chug chug starter noise!


How about if it doesnt make any noise when you try to started but the batterie is find?

No noise when you try to start the vehicle usually indicates a dead battery, or a loose or disconnected cable/wire at the starter, solenoid (starter relay switch), or ignition switch.


Where is the fuel filter located on a 2004 suburban?

It doesnt have one outside of the fuel tank.


How can you get a starter Pokemon in Pokemon gold from an older game?

that doesnt make sense


Auto transformer for a single phase motor starter?

Nah doesnt exist


Where is the starter on a 1999 Ford Probe?

a 99 ford probe doesnt exist


Why doesn't your car start--it started kind of progressively weaker as the week went on now it doesnt start at all?

My guess is it's either the battery or the charger. If everything else works that electronic in your car, its the starter.


My 2004 Chevy suburban is not turning over to start?

Hello, About your 20040 Chevy not turning over. First, when you say not turning over, do you mean the starter does not crank the engine? If this is true , then check to see if the battery is dead. if yes ,recharge and find out which device was left on, and correct. Next, if the engine turns but doesnt start, check the fuel pump relay. This is a circut breaker type device that should be found in the fuse panel. If you cannot find the breaker, turn the key to the RUN position with the window down and listen to hear the pump come on before you start the car. Hope this helps. Beyond these simple steps will require a knowledgable mechanic to diagnos further troubles.