diagram of starter in a 1993 ford probe
does anything need to be taken off to remove a started on 89 ford probe
the starter is located right below the factory air filter box
Probes were not made until 1989
look at the lower rear end of the engine on the passenger side
Check with local library for a repair manual, or automedia.com
pay someone to do it.
If the starter is spinning but not catching, the problem lies in the starter drive (also called bendix). You will either have to replace the starter or repair it by replacing the bendix.
Ford Probe was created in 1989.
It is connected to the starter.it is on the driver side of the engine at the back side.
Follow the + battery cable should be either at the inside fender or at the top of the starter
Takes about 5 minutes if it is a 2.5L V-6.