what about the fusiable links? if not u got a cut wire or bad conectin
fuse or blub is out or blown, or wiring is bad, or the relay is bad.
If the turn signals are inoperative check the hazard switch, if the hazards don't work replace the hazard switch, the signals will start working. if the hazards are ok ,the turn signal switch may be bad.
More than likely the flasher relay is defective, replace it.
Turn signals just quit working- have replaced flasher- checked all bulbs and fuses, checked all obvious wires, cleaned grounds, replaced the turn signal switch (that was an adventure). At a loss- any help out there? Hazards work fine- all other lights work fine- turn signals dead
It contains two relays, one for hazard lights and the other for turn signals. The one for the turn signals is defective and must be replaced.
The turn signals are not fused front and/or rear. If the rear are not working you need to check for power and grounds for the lights.
Well so far I have found that when I turn my headlamps on and switch to the high been and then use the rocker switch for the hazards, it will allow for my turn signals to start working again.
Turn signal flasher
multi function switch in steering column
your fuse is to strong try a lower fuse or some other one is wrong sending too match power that why to blows, or is your headlight cracked?
First check the flashers fuse .Then replace the flasher with a good one. There might be two-one for turn signals and one for 4ways. Or they could be one.
Blown fuse or bad flasher unit. Often, cars use different flasher for the turn signals and the flasher, so it is possible for the hazards to work and not the turn signals.