Antifreeze and Engine Coolant
Radiators
Chevy 350
Chevy Camaro Z28

On a 1989 Chevrolet 1500 4X4 where is the two engine block drain plugs located to flush the radiator?

646566

Top Answer
User Avatar
Wiki User
2008-12-05 20:04:17
2008-12-05 20:04:17

on my 1989 it was on the passenger side on the bottom, but i had a 89 2500 3/4, my 2 cents There is one on each side of the block in the middle just above were the oil pan bolts on the engine. They have a 9/16 head and are short.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

On V6 models, the knock sensor is located on the front (radiator) side of the engine block above the oil filter.

User Avatar

pistons in every engine are located in the block

User Avatar

goes from the top of the radiator to the engine block, joins usually at the thermostat

User Avatar

It is located on the end of the lower radiator hose connected to the engine block.

User Avatar

drain coolant from radiator, remove one of the frost plugs in engine block, install block heater in place of frost plug, refill radiator with coolant.

User Avatar

it is located on the side of the engine block.

User Avatar

The best way to identify your motor is to use the casting numbers on the drivers side rear of the block, behind the cylender head. The cylender head casting numbers may help too, they are located under the valve cover.

User Avatar

Follow the top radiator hose back to the engine block. The thermostat is usually behind the housing that connects the radiator hose to the engine block. To be more specific Its on a housing on the passenger side of the engine block.

User Avatar

They are located in the engine block and in the heads.

User Avatar

The knock sensor is located on the front (radiator) side of the engine block above the oil filter The knock sensor is located on the front (radiator) side of the engine block above the oil filter

User Avatar

follow the radiator hose to the engine, right where the hose meets the block is where the thermostat is located. Its on the the front of the engine

User Avatar

Follow the upper radiator hose from the radiator to the engine block. The point where the hose connects to the engine is where the thermostat is typically located.

User Avatar

Follow the top radiator hose back to the engine block. The thermostat is inside the housing where the radiator hose connects to the block.

User Avatar

The water coolant on a BMW 525d is located in the radiator hoses, radiator and engine block. It is circulated via a pump which helps cool and maintain engine temperature.

User Avatar

It is located on the engine block where the upper radiator hose connects to the engine. To get at it you need to remove the serpentine belt and alternator.

User Avatar

The thermostat on a 4.7L is located where the lower radiator hose hooks the engine. The thermostat is located under the housing where the lower radiator hose hooks to the block.

User Avatar

I think you have to follow the lower radiator hose to the engine block.

User Avatar

There is two on a Discovery. Located on the lefthand & righthand of the engine block.

User Avatar

Under the housing where the upper radiator hose hooks to the engine.Under the housing where the upper radiator hose hooks to the engine.

User Avatar

According to the Haynes manual, the thermostat is located by follwing the lower radiator hase from the radiator back to the engine. The housing for the thermostat is bolted on the side of the engine block facing the radiator.

User Avatar

I do not know Fiestas but usually thermostat is located in the hose that runs from the upper part of the radiator to the engine block right near the engine block. HTH

User Avatar

If you are talking about the small block V-8 Chevy engine, there is a small flat pad with an engine id number located on the block, in front and below the passengers side cylinder head. Using that number, visit web Chevrolet engine identification sites to determine which engine you have.

User Avatar

on the water pump. follow the top hose from your radiator. it attaches to the block at the thermostat housing.

User Avatar

It is located in the oil filter housing, that is located under the hood in front of the engine block by the radiator.

User Avatar

Follow the lower radiator hose from the radiator to the engine. It terminates into a device that bolts onto the engine block. Remove this device and the thermostat will be inside.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.