0
Add your answer:
Earn +20 pts
Where is the heater fan resistor located on a 2003 Pontiac grand am?
where to find heater resistor 2004
Where is the blower motor resistor located on 2006 Pontiac Grand Prix?
Resistor is located behind the blower motor assembly.
Where is the heater blower resistor located in 2001 grand am?
Pull blower its up inside hole
Pontiac Grand Am 2000 fan only works on high?
Check for a bad blower resistor at blower motor
How do you change the blower motor resistor on a 2000 Pontiac grand am?
Please email me a photo of where the blower motor resistor is and how to change it. Thanks, Michael. By the way I want it for a 2000 Sunfire not a Grand Am.
Why does the heater on a 1998 Pontiac grand prix only work on high?
The blower motor resistor circuit board has gone bad. Replace the blower motor resistor. I did Still dont work Try the fuses...Had the same problem and it was a blown fuse.
Where is the motor resistor located Pontiac Grand Prix 2001?
the resistor is directly behind the blower motor under the dash
Where is the blower motor resistor on 1998 Plymouth grand voyager?
the resistor is gonna be right off the blower motor attached to the blower motor by a wire harness should be by the heater core
2001 Pontiac grand prix heater not blowing?
Bad blower motor fuse? Bad blower motor resistor pack? Bad blower motor - checck to see if it is getting power--if so bad motor Bad switch?
I have a 1995 Pontiac grand am can you tell me where the location of heater blower is?
The heater blower motor itself is located under the hood on the passenger side of the car.
Location of blower motor resistor for 2003 Pontiac grand prix gt?
trying to locate ,the resister to the blower motor foe 2003 grand prix gt
How do you change the heater resistor on a 1999 Pontiac Grand Am?
the heater resistor is located under the passenger sides dash (near the passengers feet). there is an access panel that you pull off. some have clips holding it on, some have screws. the blower resistor is located in the blower box. the resistor itself you will not be able to see, only the connector. usually there is about 5 wires on this connector and they are in a row. disconnect the connector, there is usually 1 or 2 screws that hold the resistor in the blower box. remove screws, remove resistor from the blower box. reverse procedure for reassembly. .
