0
On a 2002 1500 HD should the brake pedal go to the floor when the truck isn't running?
Wiki User
∙ 16y ago
no! you have air in the brake system or there is no pressure for some reason. look for leaks. bleed the system.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
What does it mean when brake lights won't turn off when the truck is off or running?
Take your toe and pick UP on the brake pedal. The brake pedal may not be returning as it should.
Why don't the brake lights work but the flashers and running lights work if the bulbs and fuses are good?
Please check the Brake light switch....The brake light switch should be located near or on the brake pedal (up on the stem of the brake pedal)
What causes brake pedal to go half way to the floor on a 1999 ford explorer?
Something is impairing the brake pedal to go to the floor. Only a mechanic can tell you what is happening.
What are the symptoms of a defective master cylinder?
usually they will leak out the back by the booster, your brake pedal will slowly go to the floor at stops or the brake pedal will go right to the floor when pushed.
Can worn brake pads make your brake pedal to go to the floor?
no you have a brake fluid leak somewere
When the car is off the brake pedal is hard to push but with the car on the pedal goes to the floor?
sounds like you have a leak in your Brake Boost Controler, you should also check to see if there is any leaks in the vacuum lines that connect the engine to the brake booster.
What does it mean when you can press the brake pedal to the floor with ease?
You don't have brake fluid There could be air in the system and it requires bleeding to rid it of air. If the vehicle is an older one, the master cylinder may be porus or the bore pitted. It should be resleeved or replaced. The seals could also be flat. Jam your foot down hard on the brake pedal. Is the pedal high? Does it sink to the floor if you rest your foot lightly on the pedal? www.powerbrakeandsteering.co.za
1997f-350 brake pedal goes to floor?
ouch,are brakes adjusted correctly/ sit in vehical and pump pedal to get a full pedal,then hold pedal to see if it bleeds off and goes to floor,if it stays, replace shoes and pads if it goes to floor, there is a fluid leak somewhere is there brake fluid in the resevoir/ are there any brake fluid leaks ,check backside of wheels there is a brake fluid pump, on the chassis rail about level with the front of the front door on the left side.if this pump is bad your pedal will go to the floor
What should you check next if the fuses and bulbs are good but the brake lights will not work on a 96 Monte-Carlo?
Check the brake switch up under the dash on the brake pedal. Lie on the drivers floor, look up and then push the brake pedal with yoru hand and see if there is any kind of electrical connector that actuates the brake lights when you push the pedal in.
Brake fluid is running down the clutch pedal and when you mash the pedal the pedal remains on the floor?
Actually if the fluid is coming down the clutch pedal it is probably your clutch master cylinder going bad or the seal around it. No worries it is a cheap fix. If it is coming down the clutch pedal it has nothing to do with your brakes. Some people well most use brake fluid for the clutch.
Why does the parking brake pedal go to the floor on a 97 suburban?
probably have broken parking brake cable.
Why a 1995 Toyota corolla brake pedal is soft when the engine is running?
Brake system has air in it.
