the speedo gear is located in the tail section of the transfer case, just in front of the rear yoke, there should be a single bolt holding down the gear set, that is where it is located, remove that and change it out, just make sure you get the correct one from the parts shop, also if you have oversized tires this is where you change for correct speedo readings
You can replace the speedometer cable, on your 1988 Ford Ranger, by loosening the cable nut on each end of the cable. The cable will come off and can then be replaced.
Since you replaced the sensor, and the speedometer still isn't working it is possible that you will need to replace the speedometer cable. Check the cable first to be sure that it is still properly connected, and if so replace the cable to see if that solves the problem.
If it's an analog speedometer, first check the condition of the speedometer cable. It may need to be replaced.
Needs new speed sensor or if it has a cable to the speedometer it needs to be replaced along with the housing.
AÊ speedometer cable leak at the transmission usually signifies that you have a worn seal. There are two seals in this area, one or both might need to be replaced.
The speedometer is electronic...there is no speedometer cable.
check if it has a speedometer cable if not the speed sensor needs to be replaced
The speedometer cable (which runs from the transmission to the dashboard) has snapped. This is a two-piece cable, and the one-piece cable in later Proteges will not work. I had the transmission replaced, and the cable could never be fit in properly. This is a mechanical speedometer, so you would have to change the entire speedometer part of the instrument panel to use a magnetic/electronic speedometer.
The most common reason for a speedometer to fail is a broken speedometer cable. Loosen the nuts on each end of the speedometer cable. Remove the speedometer cable retaining clips. Reverse the process to install the new speedometer cable.
Your speedo cable is broke and needs to be replaced
I've replaced the speedometer Cable on my 87 Supra with manual Tranny and they're in two pieces the short piece which around 14" is underneath beside the transmission and could be replaced individually.
The cable that controls the speedometer needs to be replaced more than likely. That is what had to be done to a Dodge Stealth's speedometer to work properly. ==New Answer == Actually - there is no speedometer/odometer cable on a 1993 Honda. The system is all-electrical. So it has to be either a bad wiring harness/plug connector, OR a bad speedometer head (unlikely).
It does not have a cable, the speedometer is electric.
No cable, speedometer is electric
First check the speedometer cable going into the top of the transmission. If it is not broken the instrument cluster must be replaced.
It doesn't have a speedometer cable. The speedometer is operated electronically.
It doesn't have a speedometer cable. The system is all electronic..It doesn't have a speedometer cable. The system is all electronic..
No. No more speedo cables, they are replaced by electronics.
If the speedometer works, but the odometer is not working, there could be a fuse blown if the odometer is digital. If the odometer is not digital, then a gear is broken in the speedometer cable. It should be replaced.
A worn or frayed speedometer cable will make the speedometer shouter. As the speedometer cable becomes more frayed the speedometer will eventually quit working.
Most of the time, the speedometer cable breaks, and you replace it. The best way to find out, is to unscrew it from the transmission, and see if you can pull the cable out from the casing. If it checks out to be good, then it will be the drive gear inside the transmission, or the speedometer itself.
Your 1988 Nissan 300 speedometer cable is held in place with swivel nuts on each end of the speedometer cable. Turn the swivel nuts to the left. The speedometer cable will come off. Reverse the process to install your new speedometer cable.
The 1991 Geo speedometer cable is held in place with a swivel nut on each end of the cable. Turn the swivel nut to the left to remove the speedometer cable. Reverse the process to install the new speedometer cable.
The speedometer is cable driven.
I believe there is no cable to the center and speedometer