The easiest way is to put the rear of the car on jack stands or ramps. Unbolt the driveshaft from the rear end and pull it out of the transmission. Remove the small nuts holding the u-joints on the driveshaft, put in new ones, and reinstall the drive shaft.
How do I replace turn signal on a 1992 Chevrolet caprice classic I want to learn how to do it myself
if its in the reservoir it should be in the radiator of it is then it has a blow head gasket or a crack head
i have caprice 1994 classic and turn off when turn off air condition i replace the relay for in fuse box under hood and fix hope never stop again .
take it all apart and unclog it make shure you remember where it all goes or you are SCREWED
remove rear drive shaft. remove pinion yolk from front of diff.remove oinion seal replace with new one. replace pinion yolk, replace driveshaft,.. dhceck ujoints of drive shaft while out, its a good time to replace them
Maybe a bad switch or motor Try reversing the wires on switch
If there is no light at all in whole dash. first check the fuse second check the headlight control switch.
check you belt
Check the ECM located on the front driver side of the engine block. Cost about $40. It is about 3 inches wide 2 inches high and half inch thick with fine.
no actually none of the caprice or caprice wagons have one its more trial and errorfor now, look at wires ,relays, fuses, and fuel pump to fix your fuel issues
In a Fix - 2004 Flight to Modern Classic was released on: USA: 16 March 2004
In most cases you will need to replace the turn signal switch on the steering wheel for your 1983 Chevy Caprice Classic rather than fixing it. To replace it, remove the horn pad and then use a steering wheel puller and compressor to remove the steering column. You will then remove the signal along with the wiring harness and bus fuses. Replace the signal and wiring and then replace the steering column itself.