I had exactly the same problem where the unit suddenly went blank. Here is the procedure:
1- Press the mode switch several times to make sure it is not in the blank mode. OK? keep going.
2- Check the 7.5 A fuse number 10. OK keep going.
3- Remove the two screws holding the unit to the ceiling and pulled the unit
from the front to release the two clips.
4- Use a T-10 torx bit to disassemble every thing in the unit and to
get to the printed circuit board.
5Look for two surface mount resistors next to each other with 510 printed
on them. Check to see if they desoldered themselves off the board.
6- You can resolder them or replace them. I resoldered mine.
7- Use two 68 ohms quarter watt resistors (to reduce power dissipation)
and solder them in their place.
8- You can check your work by attaching the board to the wire harness and
to the plug in the ceiling and turn ignition on.
9- If everything is Ok (as I hope) disconnect the board and reassemble the
unit and install it back.
Hopefully this will help someone in the future.
outside
Outside Explorer - 2013 was released on: USA: 8 December 2013
The cast of Outside Explorer - 2013 includes: Tierza Scaccia as Herself - Host
No.
Outside Explorer - 2013 Clever Hiker was released on: USA: 4 December 2013
Outside Explorer - 2013 David B was released on: USA: 30 December 2013
Outside Explorer - 2013 Pier Peer was released on: USA: 21 December 2013
my outside temp diplay is inop
Outside Explorer - 2013 Browns Canyon Rafting was released on: USA: 25 December 2013
Outside Explorer Cathedral Gorge State Park - 2013 was released on: USA: 2013
Outside Explorer - 2013 Tree Climbing Planet was released on: USA: 1 December 2013
Outside Explorer - 2013 Seldom Seen Adventures was released on: USA: 7 December 2013