On the 2002 Thunderbird, a person can remove the hard top with a new mounting key. An automotive parts store or a dealer will be able to order the mounting key for that vehicle, if they do not have one in stock.
I have no fricken idea dude i really dont
You dont, you replace them.
"What is the thunderbird and what does it look like?" The thunderbird comes from aboriginal beliefs. The thunderbird is also known as the raven and is usually on the top of totem poles. Totem poles were carved by the Haida from trees.
* Loosen the wheel lug nuts,raise the car and support it securely on jackstands. Remove the wheel and install the lug nuts to hold rotor in place * Remove the brake caliper dont disconnect the brake hose from the caliper.After removeing the caliper bolts suspend the caliper out of the way with a piece of wire * Remove the brake pads then remove the two caliper mounting bracket bolts and detach the mounting bracket * Remove the lug nuts which you installed to hold the rotor into place and remove the rotor from the hub
Dont repair...just replace it for your safety!
if it is a 4.6 v8 you dont it is controled by the ecm
i dont believe any v6 can replace a v8
I dont know how to change the water pump??????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????
First loosen lug nuts while vehicle on ground (dont remove all the way). lift front of vehicle remove lugnuts remove caliper mounting bracket 2 bolts, require 15mm socket remove caliper bracket from rotor rotor is ready for removal
I own a 2002 kia sportage I installed warn hubs on it . It is very easy on the 2002 you dont even have to remove the wheels . remove the center cap off of the wheel,then remove the bolts on the old hub remove old hub replace with new hub tighten bolts your done but the center cap will not fit.
Manifold Air Pressure sensor. Wont run without it. It is right on the top right side of the throttle body(in the front) and its mounting bracket is held on by one of the throttle body mounting bolts. It is connected to a wire and a vac. hose about 5 inches long. Just unplug it, remove the vac. hose, and then release it from its mounting clip.(careful not to break off the plastic tabs on the sensor). You can remove the throttle body bolt if you want to,it wont hurt a thing, but dont over tighen it when reinstalling.
take the the black thing around it and then take it out dont worry it wont brake