Quantcast
answersLogoWhite
notificationBell

Top Answer
User Avatar
Wiki User
Answered 2014-10-07 02:15:26

On the 2002 Thunderbird, a person can remove the hard top with a new mounting key. An automotive parts store or a dealer will be able to order the mounting key for that vehicle, if they do not have one in stock.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Still Have Questions?

Related Questions

Where is the oil filter on a 2002 Thunderbird?

I have no fricken idea dude i really dont



How do you set the timing on a 1996 Ford Thunderbird?

if it is a 4.6 v8 you dont it is controled by the ecm


What does a Thunderbird look like?

I dont no which one you are talking about. See related links for pictures.


How do you repair seatbelt on a 1990 Ford Thunderbird?

Dont repair...just replace it for your safety!


Change the rotors on a 2001 Maxima?

* Loosen the wheel lug nuts,raise the car and support it securely on jackstands. Remove the wheel and install the lug nuts to hold rotor in place * Remove the brake caliper dont disconnect the brake hose from the caliper.After removeing the caliper bolts suspend the caliper out of the way with a piece of wire * Remove the brake pads then remove the two caliper mounting bracket bolts and detach the mounting bracket * Remove the lug nuts which you installed to hold the rotor into place and remove the rotor from the hub


How do you change rotors of a 1995 Elantra?

Remove the brake caliper but dont disconnect the brake line also remove the caliper mounting bracketRemove the steering knuckle and take it to properly equipped shop and have the hub flange pressed out of the knuckle then the disc can then be unbolted from the hubOn rear disc brakes remove the retaining screw and remove the disc from the hub



How do you take the rotors off the front of a 4WD 1998 Ford Ranger?

First loosen lug nuts while vehicle on ground (dont remove all the way). lift front of vehicle remove lugnuts remove caliper mounting bracket 2 bolts, require 15mm socket remove caliper bracket from rotor rotor is ready for removal


Do you have to use a saddle when mounting a horse?

No you dont have to use a saddle when mounting a horse, but if you plan to ride in a saddle then it is allot easyer to put it on first. If your horse is quite tall then you will probably need to use a mounting block or fence etc to get on.


How do you change a water pump in a 94 Ford Thunderbird 3.8?

I dont know how to change the water pump??????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????


How do you fit warn hubs to a 99 Kia Sportage?

I own a 2002 kia sportage I installed warn hubs on it . It is very easy on the 2002 you dont even have to remove the wheels . remove the center cap off of the wheel,then remove the bolts on the old hub remove old hub replace with new hub tighten bolts your done but the center cap will not fit.


how to remove it ?

i dont know how



How do you replace the MAP sensor on a 1997 2.4 liter Chevy Cavalier?

Manifold Air Pressure sensor. Wont run without it. It is right on the top right side of the throttle body(in the front) and its mounting bracket is held on by one of the throttle body mounting bolts. It is connected to a wire and a vac. hose about 5 inches long. Just unplug it, remove the vac. hose, and then release it from its mounting clip.(careful not to break off the plastic tabs on the sensor). You can remove the throttle body bolt if you want to,it wont hurt a thing, but dont over tighen it when reinstalling.


How do you remove the center instrument panel containing the radioCD player on a 2002 Pontiac Montana?

take the the black thing around it and then take it out dont worry it wont brake


How do you remove the rear strut in a 1997 Hyundai elantra?

* Loosen the rear wheel lug nuts,raise the rear of the car and support it securely on jackstands and remove the wheels * Remove the brake hose clip from the bracket and disconnect the stabilizer bar link on the strut.If the vehicle is equipped with ABS remove the speed sensor harness bracket bolt * Remove the strut to knuckle nuts and knock the bolts out with a hammer and punch * Separate the strut from the knuckle dont allow the knuckle to fall outward as this may damage the brake hose * Remove the luggage compartment trim panel for access to the upper mounting nuts * Have an assistant support the strut and spring assembly while you remove the three upper mounting nuts.Remove the assembly from the fenderwell





Where is the iat on a 2002 Ford Ranger?

2002 models dont have an iat sensor


How do you remove the engine on a Geo Metro?

On all Geos it is the same. Remove all the wires, pumps, and any affixed items and unplug them. Drain it of most fluids so you dont make too much of a mess. There should be 2 mounting bolts, one on each side of the Geos engine. Unbolt these. On some Geos there will be a third somewhere but most dont have that. Remove your motor and ta da! I fix Geos A LOT so if you need anymore help just ask me.



How do you remove a barn owl?

you dont they eat rodents and stuff you dont want


What lungs remove from the heart?

The lungs remove nothing from the heart.


Still have questions?

Trending Questions
Unanswered Questions
What plug replaces l8rtc? Asked By Wiki User
Who are perceptual region's? Asked By Wiki User