0
On your '84 Corvette the ignition module keeps going bad is this common and what is causing this part to keep going bad?
Wiki User
∙ 12y ago
ARE YOU CLEANING THE SPOT WHERE THE MODULE SITS AND USING THE DIELECTRIC gel for heat transfer, also using cheap modules (china)will do it,make sure your coil and the carbon center/spring and insulator are installed correctly also insulate both side of rubber insulator under coil.make sure the ground clip is under coil or it overworks coil/and module make sure your plugs are gaped right. also check voltage at battery with car running rev it up make sure voltage is not overcharging. also check inside dist for oil if oil is present replace with rebuilt. give a small tug on the green and white wires that go to pick up coil if it breaks easy replace. other then that they should not burn that often back in the day it was common but should get a least 2 years go for a original a/c delco part that insulating gel is the lifeline of how long the part will last.it also wouldnt hurt to replace the stock 195degree thermostat to a 180 as i said heat is the killer of electronics and this car runs better at 180 than 195
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Where is the ignition module 1984 Corvette?
The ignition module is located in the distributor under the rotor, it plugs in.
Where is the ignition module located 1984 corvette?
The ignition module is located in the distributor under the rotor, it plugs in.
What could cause a 1984 Corvette ignition module keep going bad is this common?
This is not common. Check to make sure there is not too much voltage at the dist.
What signals injector to pulse on a 1985 corvette?
The engine control by way of the ignition module.
Bad ignition module is also causing of not starting?
A bad ignition module will cause a no start situation in a vehicle because the needed spark is not created. It is responsible for telling the distributor when to fire.
Where is the ignition module located on a 1989 Mazda b2200?
where is the ignition module located on a 1988 Mazda b2200
Where is the ignition module 1999 Laredo?
The engine computer is the ignition module.
Where is the ignition module on a 1996 stratus?
The engine computer is the ignition module.
Where is the ignition module 97 explorer?
Where is the ignition module 97 explorer
Where is the ignition module for a Pontiac Grand Am gt at?
Not sure what the symptoms are, but I am guessing you are referring to the anti-theft module. It is located in the ignition cylinder lock. It is common for this to go bad in the Grand Am and other GM products. Not sure what the symptoms are, but I am guessing you are referring to the anti-theft module. It is located in the ignition cylinder lock. It is common for this to go bad in the Grand Am and other GM products.
How do i change the ignition module in a 1998 suburban?
Begin by removing the wiring harness from your 1998 Chevrolet Suburban ignition module. Remove the ignition module retaining screws. Reverse the process to install your new ignition module.
Where is the ignition module on a 88 tracer?
ignition control module is under the distributor cap
