There are two oxygen sensors one is called the upstream oxygen sensor located in the exhaust manifold and one downstream directly behind the catalytic converter. I think the one you are looking for is mounted in the exhaust manifold sometimes referred to as bank 1 and sensor 1 being the first in the exhaust system. Hope this helps you.
you will need a c-clamp and screwdriver and ratchett set.
Fluid and filter change should require 5-6 quarts.
You can reset the light by disconnecting the battery cable for about 5 minutes, then reconnect. You will need a scan tool.
The process of replacing the water pump varies dependig upon the engine size Please post the engine size and will try to provide you with the needed steps
Assuming it is screeching in the area of the belt and pulleys, my problem was that the belt tensioner had seized and needed to be replaced. Noise problem was solved.
Yes oxygen is needed. But in anaerobic respiration oxygen isn't needed.
Check the color of the old antifreeze. It is probably red. This would be Hybrid Organic Acid Technology and should not be mixed with other types. 2000- 2001 is around the time that Plymouth changed to this type of coolant so its important to check for the red color.
When the pilgrims came to the U.S., they needed a place to live. This is when they created Plymouth.
4.5 to 5 qts depending on the engine. with all engines (that are available in this vehicle) start with 4.5 and top off as needed after starting the engine.
if it is a serpentine belt, there is a tension pully that keeps it tight if is a v blet , u generally adjust the tension by moving the alternator
dash 5.25 door 5x7 (you will have to make or find brackets if you don't have factory infinity sound system) mid-panel/rear 6x9 This info came form experience and crutchfield
Are you loosing water and if so you will need to pressure test the cooling system. Repair any leaks and replace the thermostat. Then check your cooling fans for proper operation.
oxygen is needed for fuel to burn
no special tools are needed
Oxygen is needed for accept electrons. Eventually water is produced
3 quarts & 22 oz.
Oxygen is not needed in photosynthesis because it is produced by photosynthesis and is released from the plant into the atmosphere.
8,75 moles of oxygen are needed.
Oxygen is NOT neede for photosynthesis.... although Carbon dioxide is neededOxygen is produced during photosynthesis. This is produced by photliyis of water
You need a 1/2" ratchet or a Johnson bar. The idler pulley has a square 1/2" hole that the square on the ratchet will fit in and allow you to turn the pulley and relieve the tension.
you need to press them in.if you put your ball joints in the freezer overnight they will shrink.Then heat up your a- arm with a torch and use a jack to pop the frozen ball joints in
remove the 4 screws that hold the grill in place... remove the front grill...you now have access to the hood release mechanism, the hood can then be opened by prying the notch with a screwdriver. After that you can replace/repair whatever's needed