Car Electronics and Lights
Chevy Venture
GMC Jimmy
Ford Expedition XLT

Power door locks and keyless entry stopped working and all door switches are in good shape and is master relay located under driver seat or if not where is it located or other possible solutions?

171819

Top Answer
User Avatar
Wiki User
2010-03-08 13:10:36
2010-03-08 13:10:36
I had the same problem with my 1998 dodge ram 2500 truck. The power locks stopped working on both sides and quit responding to my remote unlock button. I read that if you disconnect the battery, things will reprogram....Well, I simply disconnected the red cable for a couple minutes and when I replaced it, the power locks worked!! Even with the remote!

I had the same problem with my 2005 town an country,i was told by a dealer that all you have to do is disconnect the battery for about five minutes.It worked for me..................good luck

well i guarantee that does not work on 95 corsica as a matter of fact disconnecting the battery worsens the other problem were having with it stalls while cornering moderate acceleration and sometimes just real hard to start

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

where is the keyless entry code for a Lincoln twoncare located for a 2003

User Avatar

The keyless entry code is located below the driver window on the exterior

User Avatar

where can i find the master keyless entry code for a 2007 lincoln mkx

User Avatar

4 switches, one on each door, the front door switches are located on the front door pillar and the rear door switches are located on the center pillar, just look for a push in button on the pillars and that's the switch.

User Avatar

The keyless entry module, on your Ford automobile, is located in the engine compartment. The module is bolted to the firewall.

User Avatar

According to AllData, it is located behind the IPC.

User Avatar

The ignition switch, also called the wireless control module, is the keyless entry computer and receiver.

User Avatar

A remote keyless system is a system designed to permit or deny access to premises or automobiles. the exact phrase "keyless entry" is solely reserved for the numeric dials or keypads that are located on or near the driver side door.

User Avatar

Dodge does not use inertia/reset switches.Dodge does not use inertia/reset switches.

User Avatar

Dodge does not use inertia/reset switches.Dodge does not use inertia/reset switches.

User Avatar

Dodge does not use inertia/cutoff switches.Dodge does not use inertia/cutoff switches.

User Avatar

It should be located on the inside of the trunk on one of the arms that supports the trunk.

User Avatar

Should be located behind the driver's door panel on control box

User Avatar

There are no reset switches on a Chrysler Cirrus.

User Avatar

It is possible that the tiny electronic momentary switches that activate each of the keyless entry functions have gone bad. Usually they don't all go bad at once but the one most used (Lock and Unlock) may begin to fail first and it may seem like you have to push real hard to get it to activate. It takes a bit of electronic prowess to unsolder these micro switches that are mounted on the small printed cirsuit board located inside the plastic housing, and install the new ones. I did it and mine now works fine. I had to locate the switches online. I drive a 2000 i30t which is a few years newer than a 1996 and three of the four micro switches had gone or were going bad. It may be prudent, if you dont want to go through all that I went through to accomplish this, simply to go through the nearest Infiniti dealer and you can purchase a replacement.

User Avatar

I believe the module is located in the console above the rear-view mirror.

User Avatar

The head office of Capita Health Solutions is located in Coventry, West Midlands, United Kingdom. Capita Health Solutions is a private company that specializes in health services.

User Avatar

Generic answer. Most Hazard switches are located within easy reach of the vehicle driver

User Avatar

Down by where the dimmer switches were once located.

User Avatar

Chrysler vehicles do not have inertia switches.

User Avatar

Cadillac does not use inertia switches.

User Avatar

Dodge does not use inertia switches.

User Avatar

Chrysler does not use inertia or reset switches.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.