Programming the remote for a 1999 subaru legacy?

Answer 1

This is probably the most frequently asked question. The answer below was hijacked from another site --Ken

Programming or Overriding the Alarm when you have lost the remote

Open driver's door.

Turn ignition key to 'On'

Press and *hold programming button* in (button under dashboard, see below*)

After 15 seconds the locks will cycle 3 times. Do not release Programming button

Press lock (left) button the remotes to be programmed. The door locks will cycle one time.

Exit programming mode by releasing Programming button under dashboard and turning key to off.

*Code Alarm Programming Button is under dashboard on the kick panel by the driver's left knee, left of the steering column. If you can't find it, it might still be tucked up in the wiring harness higher up in that same general area. The botton is recessed in a plastic ring.

This button must be pressed while programming remotes or if the battery was disconnected and the lights are flashing.