0
You will have to remove the starter housing to determine if it is the starter mechanism or the engine. Normally the starter mechanism is not too difficult to repair. But if it is engine could be very bad news.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Craftsman weedwacker pull start string is lock up?
why is the pull string on the weedwacker locked up
The Incredi Pull does not work on Craftsman 32CC weed trimmer. I need to repair so I can start the motor?
The incredi pull design is defective. Obviously there was no quality assurance. The pull line will wear through the small plastic choke idlers and render the entire trimmer useless once it has worn about halfway through.
Do you start John Deere riding mower rx 63 by key or pull start?
Pull start only
How do you start a mini moto with no pull start?
i don't think you can you will need to bye a new pull start or pull the cover of and find a piece of line that will go around the pully so you can start it
Is a 1999 Yamaha wolverine 350 pull start or kick?
i have an 05 it is electric and pull start
How do you start a push lawn mower that;s brand new?
It depends on if you bought a pull start mower or a power mower. The pull start mower will have a handle you have to pull hard to start it. The power mower should have a button that simply turns it on. Make sure there is gas in the pull start mower.
How do you start a motorbike?
kick start, electric start, pull start
How do you contract spring on craftsman lawnmower cord?
Chances are the coil spring has a broken "locking tang" on the end. They are notorius for breaking when you pull the cord to start the mower. You can go to Sears and purchase the OEM replacememt fairly inexpensivly. The new spring is stronger and contains the instructions on how to install it.
How do you replace the chainsaw tension screw on a craftsman 20 chainsaw?
Unscrew the adjusting pin. Then pull the screw straight out through the front of the cover. You have to pull hard through the thin, frictiond lock washer. -Scott www.chainsawr.com
How do you unsieze a parking brake on a 1987 ford escort?
First off, you need to take any tension out of the parking brake cable. If it is still siezed up you need to work the parking brake actuator back and forth at the wheel until it frees up. If it is still siezed up hit the brake drum with a large hammer as you pull on on the drum. If it is still seized up take cut the drum off with a torch.
How do you start a mini motorbike without a pull start?
use the kick start
How do you start a mini motor or crosser if the pull start is broken describe fully and if possible links to of how the things look like please?
repair the pull start ?
