You have to have the code. Check with dealer for that. You'll need the serial number to give them. It is generally a 4 number code. You use the "1" button on the radio to change the first number and "2" for the next number and so on and so forth. Once you have finished entering the code hold down the "skip >" button on the right of the radio for two seconds. There will be a beep and it will go back to the radio.
With radio on press and hold mode button on the steering wheel controls. After a few seconds the word 'others' will appear on the screen. Press and hold mode again until 'curve 0' appears. Using your channel selection scroller, scroll until it reads 'curve 2'. Press and hold mode again until you see 'rear on'. Press and hold mode again and after a few secs the beeping will stop. (Applies to Scenics from 1999-2003).
You need to go to the dealership to get the code. I was told it needed to be the original dealership in which it was first bought but don't quote me on that.
If you don't have the manual (which will have the code in the section for the stereo) call the Delaership with the car's VIN and they can look up the safe code
I had to go to a dealership to get the radio unlocked, also the cause; ( radio locked) was Battery Failure. After I puchased a new battery I found the radio use to be locked.
I have an 1996 Audi Quattro A6 i changed my batteri and my radio went to safe mode. How do i get my radio off safe mode?
Press and hold down the "mode" button until the radio beeps, then enter the code. I can't remember if you have to press "mode" again after entering the code or not, but i don't think so. If you don't know the code to your radio you will have to go into a L.R. dealership and they can tell it to you.
Turn the radio on. Press SET button. This puts the radio in (Program) mode. Press SEL button. This puts the radio in (Set Hours) mode. Press TUNE button up or down to adjust hours. Press SEL button. This puts the radio in (Set Minutes) mode. Press TUNE button up or down to adjust minutes. Press SEL button again to return to normal mode. Pressing the SEL button after this changes the display to (Radio Frequency) display or (Time) display.
You need your operator's folder. In there is a booklet about the radio. it will have a code you need to enter to get the radio out of "safe" mode. the code is unique to each radio and car.
The mode of communications radio equipment deal with is radio frequency communications. Due to the concern of public safety radio communications now send signals digitally.
KEN mode was created in 1999.
Fresh Mode was created on 1999-04-20.
Yes Pandora radio works on a mac. it only works though if it's not in private mode. so if it is on private mode it will not work.