If you're just adding an amp for a subwoofer be sure to get an amplifier that has speaker level inputs and you're good. If you're looking to keep your factory head unit but want more power/clarity all around (with or without new speakers all around) and want to add an amp: a few years ago you would've had a problem, but now sound processors are available that allow factory head units to have additional power via amplifiers. Check out Crutchfield.com >this company is highly recommended (have used them numerous times myself)>excellent tech support and even better customer service.
in the stereo
A mono amplifier. You need two for stereo.
The amplifier is under the stereo itself on the floorboard. If you open up the lower compartment by the floor under the stereo and remove it the amplifier is right behind it.
yes , you need the converter from high to low, found at walmart, connect to speakers, if have factory amp install before the amp
Yes. An amplifier can be added and intergrated into your system.
How do you remove stereo from 2000 nissan pathfinder?
Yes this amplifier is a mono amp so it is internally bridged. It does not have a stereo output.
It could be a 2 channel stereo amplifier.
A high fidelity amplifier allows a stereo to push more wattage to a set of speakers. This reduces distortion and creates a cleaner sound from the stereo.
What do you mean charge the amplifier? It's not a battery, so you just turn the stereo on. When the stereo goes on, the remote wire will turn the amplifier on and you're good to go.
The Factory radio for the 1997 Nissan Maxima was a capable stereo for its time . Now they have made aftermarket stereo CD players which has more power and also other features which weren't available in the late 1990's . Here's a site you could check out : How to Install an Aftermarket CD Player Into a 97 Nissan Maxima | eHow.com http://www.ehow.com/how_6508304_install-player-97-nissan-maxima.html#ixzz1JEPigBBN
A stereo power amplifier is simply a two channel power amplifier. You can runn it in a couple of ways; Stereo, mono or bridged. Stereo has a seperate left and right signal in and sepetate out. Mono is one channel in and both output channels reproducing the one signal in. Bbridged gives you the same as mono BUT it uses both channels as one output.