Luckly, I just did this today. Ok You first have to remove the fuse panel which is just above your climate control settings. There will be 4 Phillips head screws just above below the fuse cluster. Remove those 4 screws and pull out the vent panel and audio console.. There will be 2 screws just right of your instrument cluster Remove those 2 screws. If your driver side door is open you should see one screw just below the molding on the extreme left of the instrument cluster. Remove that one screw and then you should be able to pull off the plastic molding to reveal 2 more black Phillips head screws and 2 copperish screw/nuts with a Phillips driver compatibility. Remove those 4 screws and then you can pull out your instrument cluster.
One bit of a warning though.
Do not cut the retracting silver wire just under the cluster. I did this and now i cannot see what i am in when i go to put it into drive or reverse. Stupid me.
Remove the dash and remove the instrument cluster, the lights are in the back of the cluster.
It is not difficult. First you have to remove the 12vot cigarette lighter plastic and then remove the radio. 4 screws for the radio. Then you have to remove the panel that goes from the radio up to the instrument cluster. This panel has 4 screws. 2 of them are on top of the instrument cluster (visible) and the other two should be visible after removal of radio.
Remove the 2 screws at the top of the instrument cluster bezel (or dress front cover), carefully pry out with a small screwdriver and set aside. Remove the 4 screws that hold the instrument cluster to the inner dash and pull out. Turn instrument cluster over to access the bulbs for removal and replacement. Twist the bulb retainer to remove.
Yes
Toyota Previa was created in 1990.
Behind instrument cluster.
no
how to replace a heater matrix in a toyota previa
yes
You need to remove the cupholder*4 screws* and lower the cigaret lighter and cup holder underneath are two bolts,remove the two bolts.Remove the fuse cover and you will see four screws remove the two outer screws and pull out the radio unit and the vents. When you remove the radio cluster will show two screws holding instrument cluster bezel.Near the the door is a vent held by clips use a flat screwdriver to remove the vent.Just pull the instrument cluster bezel and it will come off.
Toyota previa starter motor wont engage
Not all toyota previa are automatic supercharged as some are manual.