0
I have found that the most effective way to remove rust are citric acid based stain removers. I suggest a small amount of granular citric acid (about the size of a Golf ball) be placed in a stocking or a sock and held directly over the stain for 1-2 minutes at a time. Be careful not to leave it there too long as it can leave a very 'clean' spot in your pool surface that will be noticeable. If it is a severe stain, try hydrochloric acid or a pumice stone but be careful not to damage the surface (or yourself) in the process as acid is very hazardous. S
Wiki User
∙ 6y ago
Add your answer:
Earn +20 pts
Is it possible to change a concrete pool into a liner pool if your inground concrete pool has cracks along the side down near the bottom?
Yes it can be done
Replacing swimming pool ladder anchors in concrete what is the best tool to use to cut out the concrete?
It depends on how large a hole you want to leave One way is to get the smallest concrete cutting disk you can hire and cut a square piece of concrete with the old anchor in it drill some holes in the side of the newly exposed concrete put pins in them sticking out so that when you refill the hole with new concrete and the new anchors the new concrete can't start moving. Use stainless steel for the pins, they can be bolts or any thing you can find, so long as they don't rust and are reasonably strong.
Can you die swimming into the wall of a pool?
doubtful unless you just completely werent looking. But there is a possibility of running and hitting your head on the concrete or side of the pool which is the number one rule of no running is enforced
How do you put a inground pool into the side of a hill?
With lots of dirt fill. make sure it has been compacted and be vigilant of the washouts after the pool has been intalled, Use concrete in the washouts to prevent further erosion.
What product do you use to seal a underground pool from outside water through side walls?
It would depend on what kind of an in-ground pool you refer to, i.e. gunite, concrete, block, vinyl liner, wood, or fiberglass.
Is rust underneath a patch in a vinyl pool liner cause for concern for an in-ground pool?
is the patch on the side wall? most likely the wall is rusting.. not a HUGE concern but when and if u have the liner replaced i would deff have it looked at... not usually a hard to fix problem
Can you install a light on a concrete pool after its been built?
One option is to install overhead lighting to avoid what could be a major project trying to dig out earth from behind the pool walls. Advanced technology though uses FOX lines (fiber optics) to transmit the light into the pool - the light source is off to the side away from the water.
What side of the summer pool cover touches the water in the pool?
Do I put the bubble side down to hold the heat in?
Which way up dose a solar pool cover go?
The side of the pool cover with bubbles is the lower side.
If your pool is made of both fiberglass and cement or gunite and the sides are fiberglass but the bottom is either cement or gunite is this a fiberglass pool that was filled with cement?
No. An older (possibly better) type of Fiberglass pool was constructed in this manner, with a concrete/Gunnite/Marcite trowled bottom and Fiberglass panels at the side of the pool. Panels are caulked together along vertical joints. Actually not a bad deal, but caulked joints must be maintained. Once the concrete starts showing through at the bottom of the pool, its time to drain and resurface. Bottom of pool should be acid washed every 3-5 years to keep it sparkling and remove mold, mildew, stains. If bottom surface is chipping off, its getting close to time to resurface bottom of pool. Bottom is treated just like any concrete/gunite/Marcite pool surface. Sides are simply brushed, caulked in timely manner.
When was The Concrete's Always Grayer on the Other Side of the Street created?
The Concrete's Always Grayer on the Other Side of the Street was created in 2004-09.
What do you use to make side walk?
concrete
