0
The flywheel should just be a friction fit. You can use an inexpensive wheel pulling tool-about $10-$15. If it is not rusted in place you might be able to remove it by using a pry bar to push up on the flywheel from underneath, not too hard, then tap the wheel with a hammer to work in off. Helps to rotate the wheel to pry up on opposite sides so it doen't get cocked to one side and jammed.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you remove the flywheel on a Briggs Stratton engine?
It requires a special puller.
Briggs stratton flywheel?
This is not a question!
Where are the points on a 12.5 Briggs and stratton engine?
under the flywheel
Does flywheel key balance Briggs and Stratton engine?
No. It positions the flywheel in the proper place for the ignition timing.
How do you replace alternator on a Briggs and stratton engine?
For most Briggs and Stratton engines the charging system is under the flywheel. You will have to remove all the shields that cover the top of the engine and the flywheel and then remove the flywheel itself. Once the flywheel is off the stator is exposed. Depending on what model you have there will be a series of screws that hold it to the block. Just unplug the wire connector and remove the screws and it will come off with a little wiggling. Make sure that all the magnets on the bottom side of the flywheel are in place and secure or replacing the stator will not do you any good.
Briggs stratton engine How do you change a condenser on a 4hp?
you have to remove the flywheel, take engine cover off, remove flywheel, its under it, next to the points, you have to remove the flywheel, take engine cover off, remove flywheel, its under it, next to the points, you have to remove the flywheel, take engine cover off, remove flywheel, its under it, next to the points, you have to remove the flywheel, take engine cover off, remove flywheel, its under it, next to the points,
Briggs and stratton 6.75 magneto gap?
Most of the Briggs engines can be gapped simply with a business card between the flywheel and the magneto.
Where is the coil on a Briggs and stratton engine on a tractor mower?
The coil is under the cowling on top of the motor where the flywheel is.
How do you pull a flywheel off an 8 horse power Briggs and stratton engine?
use a wheel puller
Where can I find a Briggs stratton flywheel replacement?
If you know your part number of even model number, you can go to eReplacementParts.com for the Briggs and Stratton parts your looking for. The site features part lists for each engine or motor and includes thousands of detailed diagrams to help you replace the flywheel once you get it. All in all, they are a very good site for finding tool parts in general but for Briggs and Stratton parts, eReplacementParts is the place to go.
Where is the flywheel housing on a Briggs and Stratton engine?
It is the whole assembly containing the pull start (if applicable) or the metal or plastic shroud surrounding the flywheel (it spins when you start the engine ).
How do you adjust timing on your 17.5 Briggs and stratton lawnmower engine?
There is no way to adjust the timing on a 17.5 Briggs engine. The magnet is on the side of the flywheel and there is only one way the flywheel can line up. All you can do is make wure that the coil is gapped correctly.
