Should be located in a removable housing at the engine end of the upper radiator hose Drain about 1 gallon of coolant from the radiator Remove this housing Make note how thermostat is installed Clean both surfaces Replace thermostat and gasket Re-install housing Re-fill coolant slowly to prevent an airlock Start engine and look for leaks Run engine to normal operating temperature with heater on Re-check coolant level
information on how to change the themostat on a 94 Pontiac Grand am SE 2.3 liter
Is the engine a 3.1? If so it is easist to remove the crossover pipe, then the thermostat housing.
Cause it does
At the point where the upper radiator hose clamps to the engine is the thermostat housing. Inside is the thermostat.
under the throttle body
I recently obtained a 99 Grand Am Se and according to the tire dimensions on the drivers side door the car I own is supposed to have 16inch tires.
My 99 2.4L get 20-22 city/25 on the road
Yes, but just below the thermostat.
.A picture of the thermostat location on a 1999 Grand Am SE 2.4 liter engine can be obtained from most General Motors dealerships. The picture can also be found at most local libraries.
One per cylinder.
what year
It doesn't have one if its an SE.