Ford Taurus
Heater Cores and Blower Fans
US Army

Replaced the heater core on a 1988 Ford Taurus and now you dont have bilnkers or hazards what might be the problem?

678

Top Answer
User Avatar
Wiki User
Answered
2005-10-09 19:05:45
2005-10-09 19:05:45

recheck where you were at to replace the heater core,might have accidentally un plugged something.also look into blown fuses . good luck

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


I had this exact problem on my 1996 Taurus. The solution in my case was to replace the transmission range sensor. I replaced it myself. It was easy to change. I can't say if that is what is wrong with your Taurus, but it was what was wrong with mine. Good Luck! This was also the problem with my '96 Taurus... part was also refferd to a Nuetral Safty Switch"

Maybe you have a problem in your main wiring harness. No fun.. Could also be an electrical sensor.

You can't repair it. It must be replaced.

If you have a Ford Taurus and the high beams stay on all the time, chances are that you have a defective control switch. The dome light uses a separate switch but is likely to have the same problem. To correct the problem, both switches should be replaced.

my transmission is not shifting on my 2005 Ford Taurus what could be the problem

Possibly the O2 sensors need replacing. There's one in each exhaust manifold.

This is a internal problem, I had same thing wrong and I replaced all I could then brought it to shop and he said the bands are slipping

Had the same problem off and on in my 1999 Taurus. The speedometer needs to be replaced. The problem is in the speedometer and not the transmission like I was initially led to believe. My mechanic said it wasn't that big of a repair.Coincidentally, the vehicle speed sensor feeds information to both the speedometer and the transmission....See "Related Questions" below for more

I just had mine replaced and there were 3 total.

The size of a transmission pan in a Ford Taurus is usually 5/16x18. However, this may vary if you've had the pan replaced in the past.

Ive read that most Taurus cars have a faulty pulleythat the serpentine belt runs through which makes irritating noises such as squeaking, humming, tilted steering. It must be replaced to fix the problem. Belt conditioner is a temporary fix however u would have to use it daily. Highly reccomended to just get it replaced. hope this helps.

I have a problem to change a spark plug.

Never. The Taurus engines...both the Vulcan and the Duratec V6s...both have a timing CHAIN that lasts the life of the engine, not a timing belt.

Nope. Money is a problem in this, because money falls through Libra like sand, and Taurus would get very mad about this.

You need to "bleed" the brakes at each wheel. R

I just had this problem with my 94 taurus. It turned out to be the light switch on the steering column. I am not sure what it is called, but it is the "lever" you use to turn on the brights and blinkers. My hazzard lights were not woking either. I replaced it and all has been good for about a year now. Hope this helps.

There is a problem with the emissions system.

The Taurus SHO has a timing belt that must be replaced every 100,000 miles. All other Ford Taurus's have a chain that should last the life of the engine.

my 1992 ford Taurus quit running and it would take a few minutes to start,but i noticed when it would die and i turned the key forward i couldn't hear the fuel pump. I replaced the integrated control modual-icm,and i never had a problem again. See "Related Questions" below for more

There are several things that can cause your 2002 Ford Taurus to hesitate when accelerating. A dirty air filter will cause the problem.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.