Turn the key to run position Depress the accelerator pedal to the floor 3times in 5 seconds. The light should flash and the go out. Turn the key off and the start the engine.
Put the car in Park. turn on the power but don't start the engine. press the brake three times in quick secession.
You can access the middle brake light from the inside of your 2000 Dodge Neon cargo compartment. Remove the brake light wiring harness. Remove the brake light retaining bolts. Reverse the process to install the new brake light.
i have a 2004 Chevy Malibu i nedd to find the reset button please
disconect reconect computer should reset
The check engine light codes have to be read and removed with a scanner on anything after '96.Auto Zone will do it free.GoodluckJoe To reset the "check engine" light, simply disconnect the battery for a moment and it will go out. This worked for me on my 98 Ranger. try checking the co2 sensor. A sure fire method, if you can access the fault codes, is to remove the jumper wire while the codes are displaying. Pull the codes from the computer, match the code to the troubleshooting procedure, follow the procedure to find the source. Repair the source, light will go out if that was the only problem. There are "monitors" or self tests the computer runs the car through a drive cycle, if a problem occurs, it may not run all of the self tests until that problem is taken care. Therefore, another problem may exist. It is emission related. OR hook up a scanner that is capable of clearing codes, and hope that none are still active. Pukenstein@aol.com Unless it is a hard code...OBDII hard codes will not reset simply by fixing the problem..they have to be reset with an OBDII scanner Advance Auto Parts has em too
yeah
go to auto zone they will do it for you
Turn the key to the run position and depress the accelerator pedal to the floor 3 times in 5 seconds. The light will blink and then go off.jd
The check engine light problem will have to be repaired in order to have someone with a scanner to reset it. If the repair is not made then the light will come back on immediately.
try to reset oil light on 528i bmw year 2000
Turn on the ignition but do not start the engine. Depress the accelerator to the floor 3 times within 5 seconds. The oil light should blink and then go out.jd
Turn ignition to on without starting engine and press all the way down on the accelerator 3 times within 5 seconds
Take it to your Dealer for repairs. It could be any number of sensors or the contacts in the column.
With an automotive computer or they'll do it for free at any AutoZone or PepBoys, or any automotive store.
after fixing the whatever abs problems or traction control problems you had the light should go off automatically. if it does not you have not fixed the problem.
There is one screw that holds the fog light it into place.Unscrew that screw and the fog light will pull out of the bumper.
oil servis reset without using a computer http://www.kofla.net/chevrolet.htm
If the change oil light comes on, then a person needs to change their oil. If a person changes their oil the light should turn off.