How do you reset 2008 honda element service light?
how to reset a tire sensor for a 2008 Honda civic si
There is no such reset button on your Honda CRV.
With the ignition off, push and hold the odometer reset button, now turn the ignition on without starting the engine. After 5 seconds the maintenance required light will go out and reset.
I use a scan tool after repairing the cause of the code that turned the light on.
what do you reset the cehck engine light patriot manual transmission 2008? thanks for you support.
Oil change and tire rotation.
how do you reset check engine light in 2008 buick lucerne
How to Reset Maintenance Warning Light on a 2008 Toyota 4Runner
Hi I have cruiser 2008 gxr how is reset t.belt light
I means change the oil or rest the oil % indicator.
Adjust the tire pressure to specs and drive it. It will reset itself within a short drive if all tires are set to the correct pressure.
turn key on hold reset button down located on the left hand side of the dash , it will start blinking lift your finger and press two more times and it is reset.
2008 Honda Civic tail light fuse is #15 under the dash.
Key on engine off, press gas pedal to the floor three times, cycle key off ans on. Light should be reset.
Push and hold the odometer reset button while at the same time turning the ignition switch to the on position. (Do not start the engine, just turn the ignition on). After about 5 seconds the maintenance light will reset and go off.
buy a new car
how do you reset a 2008 kia spectre tpms light?
hold the speedometer reset button down while you turn the key on for about 15 seconds.
change the oil
Turn on Ignition - depress gas pedal 3 times
The easiest way is to check and make sure your tires are inflated to the sticker on the door post. If the pressure drops 25% or more then the light comes on this would be around 25PSI for most cars. Second option is to take it to the Honda dealer and let them reset it. usually #1 takes care ot the problem
how do i change the oli im my 2008 Honda shadow vlx
normally disconnecting one of your battery terminals and reconnecting it will reset the trouble light.
how i reset check enging light manually at mitsubishi fuso 4m50