0
Rotors to thick and you will lose threads on lugs is this ok?
Dmaley
If you are loosing threads on the stud, Then it is the wrong rotor. And yes it does matter. You need all the threads to hold the wheel on.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you take off the front end rotors on a 1988 full size bronco?
Dissasemble the hub the pull off the rotor with the lugs then use a hamer to punch out the lugs out of the rotor
Are the wheel lugs on a 1988 s10 blazer reverse threads?
No. Lefty=Loosey, Righty=Tighty.
How thick is a car wheel?
It depends on the material it is made of and how it is made( stamped steel, cast or forged aluminum). Stamped steels are the thinnest 1/8 thick at the lip/bead, up to 3/16 thick at the lugs/hub. Cast aluminum are the thickest at 3/8 thick at the lip up to 1 inch thick at the lugs/hub.
How loose should a rotor be around wheel lugs?
The slip-on type of rotors typically don't fit snugly on the wheel lugs. There is often quite a bit of play, which is fine as long as you never drive with loose wheel lugnuts.
Are lugs reverse thread dodge van?
No!!! It would depend on the year early 1960 Dodges had reverse threads on the drivers side.
Lug pattern for a 1967 fleetwood cadillac?
If i am understanding your question coreectly you tighten them in a star pattern. if more then 5 lugs do the best you can!!!!!!!!!!!! This applies to all wheel lugs on any vehicle. keep in mind that one side will be reversed threads on an older vehicle such as yours. Don't try to bradk them loose turning them the wrong way or you will be replacing broken lugs!!!!!!!!!!!
What is lugs earthing?
it is also same as earthing lugs,there is no differenence earthing lugs ang lugs earthings.
What are the lug nut specs for 2001 tacoma?
M12 x 1.50 is the lug specs for this truck. Remember to use torque sticks to put the lugs on so you don't Couse damage to the rotors or wheels.
Where can you find rotors for a 1985 dodge power ram 4x4?
Front Rotors can be found at most auto parts stores. They will look like a slip on rotor for today's cars, but will be held to the hub via the wheel lugs from the back side. Not to diffecult I just changed them on my 87 took about 3hrs for both sides.
How do you remove brake rotors from part with lugs on a 1996 Toyota T100. I already know how to remove the rotor from the front wheel axle.?
On 2.WD pick-up models, the disc is bolted to the backside of the hub.
What part of a car has interchangeable parts?
All of them are interchangeable but if you mean moved around on the car some bulbs tires rims lugs knobs some rotors some lines screws and bolts not much more
What causes vibrating when braking at high speeds?
Possibly warped rotors, loose wheel bearing, or a defect in a tire. Inspect your tires carefully, looking for bulges, or any other abnormality. If you find none, then you will need to check the wheel for looseness, and if it is not loose, then have the rotors removed and turned. Replace the front pads at this time. I would suspect you will find the rotors are warped. When replacing the wheel after service, be sure and tighten the lugs nuts to the proper torque, (found in you owner's manual). Tighten to tight and the rotors will warp again.
