depends if you are using any detergents some say cold some say hot and some say in the pot nine days old if I was you I would use hot then cold and then hot and cold because then it would expand and contract and hopefully loosen up all the debris and if its a water heater core I would use white vinegar.
By Andreina Urdaneta A clean water heater will heat and maintain water better and last longer. Once a year, flush your water heater, and in extreme hard water areas, at least twice a year. If you feel up to the challenge, here are some tips to help you in a basic cleaning. 1 Turn the water heater and the cold water supply to the water heater off. 2 Hook a high-quality garden hose to the drain valve, and place the other end in an area where hot water will not cause damage. 5. Open the drain valve. 6. Disconnect the cold water pipe on the top of the water heater. This step will let air into the water heater so it will drain. When the water heater is empty, close the drain. 8. Pour tile cleaner into the cold water, leave for a couple of hours and drain the detergent out of the tank. 10. Reconnect the cold water supply to the water heater. Open the cold water valve and let the water heater flush for a couple minutes. 12. Close the drain valve and open the hot water faucet nearest to the tank, and let the water heater fill. 13. When water starts to come out of that faucet, reopen the drain and let the water heater continue to rinse. After all the air is out of the water heater, turn it back on. Take care of your water heater, and it will take care of you. If you keep ignoring the task, your water heater may just leave you in the cold.
You should have a hot water heater for the kitchen for sure and also to have for the bathrooms. I personally like to wash my hands in hot water not cold.
Check piping. Make sure cold line going into cold side of water heater and hot side coming out hot side. Cold feed for water heater should come off main cold line. Make sure valves are open to and from water heater.
The two pipes going into the heater should be marked with either Hot and Cold or a H and C. There should be a shut off valve on the cold side, but sometimes there is one on both sides. If the piping is visible, you can follow one or the other to where it comes into the house. The water heater is usually the first thing the water line runs to.
cold
You should check and adjust the heating temperature, then turn on the cold water to fill the tank.
Probably blocked heater matrix. Best thing to do is flush the cooling system with the best stuff you can get.
If water is only drawn from the cold faucet, then no, the water heater is not involved. However, if water is drawn from the hot faucet- even for a few seconds- hot water IS withdrawn from the heater, and fresh cold water drawn in to be heated- even if the hot water did not make it all the way through the pipe to the faucet- and the water heater will work to heat that fresh cold water.
There may be something wrong with your water heater. Try turning up your water heater in your house. If that does not work, you should contact either a plumber or someone who works with furnaces and heaters.
When you flush your toilet, cold water is used, this diverts cold water from the sinks and showers, resulting in diminished cold water flow momentarily at the sinks and showers, so, less cold mixed with hot, = hotter sinks and showers.
Yes
Cold water pipe.