The distributor cap is installed with the marked # 1 position facing away from the engine ------------------------------------------------------------------------------------------------------ The distributor rotor turns CLOCKWISE , so start with the # 1 position and then install the spark plug wires going CLOCKWISE ( 1 - 5 - 3 - 6 - 2 - 4 ) which is the spark plug firing order ----------------------------------------------------------------------------------------------------------- also , the engine cylinders are numbered 1 to 6 , front to rear
The distributor cap is located on the top of the distributor on a 1996 Sunfire. It is connected to the spark plugs via a wire.
The Toyota Camry used distributors in its engines up to 1996. Just follow the spark plug wires. They will lead right to the distributor.
Your distributor is probably bad.
The 1996 GMC Sierra six-cylinder spark plug gap, is .009. Most spark plugs are pre-gapped by the spark plug manufacturer.
Start with a bad Spark Wire Followd by a new Distributor Cap and Rotor button. Pening that failure, replace the sparks.
On a 4 cylinder it is on the end of the cylinder head. On a 6 cylinder it is part of the distributor.
It would be a vented opti spark.
Six cylinder, it is inside the distributor. Four cylinder, it is on the driver side end of the cylinder head.Six cylinder, it is inside the distributor. Four cylinder, it is on the driver side end of the cylinder head.
four, as it is a four cylinder engine with one spark plug per cylinder.
The 2.4L does not have a distributor. On the 2.5L, it is on the driver side end of the rear cylinder head.
When a 1996 Jetta is not receiving any spark a diagnostic test should be done to troubleshoot the ignition system. Several problems can cause no spark such as spark plugs, the ignition coil, distributor, or spark plug wires.
The 1996 VW Polo distributor wire order is 1-3-4-2. The number one spot should be marked on the distributor cap.