answersLogoWhite
Ford Ranger
Ford Ranger XL
Ford Ranger XLT

Speaker sizes 89 Ford Ranger?

567

Top Answer
User Avatar
Wiki User
Answered
2008-11-10 02:26:37
2008-11-10 02:26:37

i believe the doors are 6" rounds and the back speakers are 6x9s, if not 5x7s.

001
๐Ÿฆƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


how do i take the fan cluch off a 89 ford ranger yo replace




The engine cylinders on a Ford Ranger V6 are numbered : firewall 3 - 6 2 - 5 1 - 4 front of Ford Ranger ( V6 )


check map sensor that was the problem in my 89 2.3 ranger


5 quarts with filter change - according to www.the rangerstation.com


According to Auto Zones' website the proper gap is .044" on the '89 2.9L.


As a general rule of thumb, 1989 Ford Rangers share parts with all Rangers up to the year 1992. There are some exceptions to that, not sure if the windshield is or not.


The engines in a 1989 Ford Ranger would take ( " regular " unleaded gasoline , 87 octane ) * 2.3 L four cylinder / 2.9 L , V6


Throttle plate may be stuck - try to free with a screwdriver


yes it will ,but use the torque converter from 89 trans


There should be about 8 bolts under the bed and the wiring harness


The only permanent repair is to replace the gasket with a new one.



Not from the factory , it either has the 2.3 liter 4 cylinder or the 2.9 liter V6


According to Gates ( they make timing belts etc. ) the 2.3 liter - 4 cylinder engine in a 1989 Ford Ranger is NOT an interference engine so there should be no valve damage


on the 89 I used to have one was under the driver side attaced to the frame rail on the inside and the other was in the tank


1-4-2-5-3-6 w/ distributor rotation "clockwise"


Location of starter on 89 ford f150


The front engine cylinder / # 1 , 2 , 3 , 4 from front to rear


The temperature sending unit can be checked cold, and then hot, for resistance change. The test is performed with an ohm meter.



I would have to say that would be your pull switch on the dash. I had the same problem on my 88 Ranger, just replace it. I do not remember the cost of part or specific name of part


It depends on the body style. I have a 89-92 body style ranger. I have 31in ten-fives on it and i had to cut about half an inch out of the front fenders. My friend has a 2001 with 33in ten-fives and didnt rub at all.


no with out a fuel pump pretty much any car wont run....unless your pouring fuel right into the carb



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.