0
The brake pedal slowly creeps to the floor when you hold the brakes on a 1994 Ford F350 with rear ABS only What can you do?
Wiki User
∙ 14y ago
Check the ABS control valve located on the inside of frame rail, drivers side. They can bleed off internally just like a master cylinder can.
any external leaks, how are the drums? most likely look for external leaks in rear drums. if no leaks it has internal leak in master cylinder. replace the master.
He is right just wanted to let you know that the control valve is refered to the RABS valve if you go into the local dealership. They should know what you mean. And yes it sucks no easy way to test the valve. I have seen and replaced many in my day and they are known to fail. Start there first. Then proceed above.
Powerstroke 57
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
The brake pedal slowly creeps to the floor when you hold the brakes on a 1994 Ford F-350 with a Diesel eng.?
Check your brake fluid. Next maybe your brake lines need to be bled. OR you just might need new brakes.
Why does brake pedal go to floor on 1991 buick park avenue?
First, make sure the master cylinder is filled with brake fluid. If it is low, there may be a leak somewhere in the brake lines or a brake cylinder. If the master cylinder is bad, you can normally pump the brakes up, but the pedal will slowly sink to the floor again. The master cylinder needs to be replaced or repaired.
Why do the brakes go to the floor before beginning to respond?
you either need a new brake master cylinder or your brakes need to be bled
Why would a brake pedal held to the floor suddenly lose tightness and brakes not working?
Have your brake system checked immediately! (by a proffesional)
You replaced rear brake shoes and drums your brakes are now fading and have to be pumped to stop There are no leaks and the adjustment is up where it should be?
Try bleeding your brakes. If there is air in the system it can give a spongy feeling to your brake pedal and require you to pump your brakes and/or put your brake pedal to the floor.
Having brake problems on a 95 ford ranger xlt 2.3l v6 you replaced master cylinder brake booster bled the brakes pedal still goes to the floor?
You need to bleed the brakes.
How do you tell when the brake master cylinder is out?
Master cylinder may be leaking, brake pedal may slowly fall to the floor when you are stopped with your foot on the brake.
What is the reason of when you apply brakes the brake pedal goes down?
If sitting still in your car with the engine running you can apply the brakes and the pedal slowly goes towards the floor you have a defective brake master cylinder. The only repair is to replace the master cylinder. This is a very dangerous situation and must be repaired immediately. Failure to replace the master cylinder may result in an accident.
What are the symptoms of a defective master cylinder?
usually they will leak out the back by the booster, your brake pedal will slowly go to the floor at stops or the brake pedal will go right to the floor when pushed.
What is wrong with the brakes in 99 Renault Clio had to depress brake pedal to the floor in order to stop the car?
i do not no
What causes brake to go down to floor if brakes have been replaced?
Air in the brake system- Brake system needs to be bleed and fluid needs to be added while you are doing that.
Just changed your front and rear brakes and shoes. The brake light turns on until you put in more brake fluid. The brakes feel if they were almost touching the floor at times. What could cause this?
If you are losing fluid and the pedal is low, you have a brake fluid leak.
