Sometimes an electronically controlled (or manually for that matter) mirror will become displaced due to a bump on the housing, which allows a certain amount of movement. This is so the mirror doesn't get snapped off if it gets bumped.
When this happens the control mechanism at the back of the mirror is dislodged and must be coaxed back into place, it's not too difficult, just have a good look at it and work out what you need to do.
The cut off switch is between drivers seat and your door. Little black button.About the size of a quarter.
http://wiki.answers.com/Q/How_do_you_intall_break_light_switch_for_2001_daewoo_nubira"
Most likely on the gear shift under the handle on the righthand side.
its between the driver seat and the door jam on the floor beside the seat
Looking from front of car to engine look just behind headlamp on top of gearbox and theres a two pin plug connected to switch which screws into gearbox housing
It's possibly the switch or the motor in the door. I have a 99 Nubira (Australia) and the window winder motor died. I got a 2nd hand/used one with the assembly and swapped it. Now it works fine! Jeff in Oz
Replace the rocker switch unit in the door. Usually about $10-$15 from wreckers. Common effect is window will go down but no up...(Burnout of switch unit.) Will master on drivers door work window?? If yes, then above is the problem...
possible turn signal switch failure common on gm cars
i believe you need to buy a comlete new break switch.if the lever on the break switch is vertical to the floor,i think it might be bad.
Were and how do you change a brake light switch on a Daewoo Leganza 2001
AnswerThis code is related to the sensor switch on the Air Intake Unit. Check your cable under the hood of the car, make sure it is plugged in, when it is, clear the code and start the engine. The code should be gone. If the problem persists then you might have to replace the cable Owner of a Daewoo Nubira SE
stop light switch is located above brake pedal under dash