answersLogoWhite

0


Best Answer

Make sure the resistance (ohms) from the sending unit matches the gauge's range. It's smart to also make sure the float works properly before dropping it in by doing a bench test on it. Then make sure the gauge is working properly. You will need a multimeter and lots of research time if you have not done this before.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: The fuel gauge doesn't work in your 1991 Camaro RS the gauge has been changed and so has the sending unitWhat could be the problem?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

I have oil coming out of oilsending unit on 1996 Chevy Camaro V6.Do I need to replace it or is it another problem causing this?

Replace the sending unit, it is defective.


2001 v6 Camaro temp sending unit location?

where is the tempture desending unit on a 2001 camaro


1983 Chevy Camaro z28 fuel sending unit where can I get one when general motors can't even find one?

Where can I get a fuel sending unit camaro Z28 1984


Where is the temperature sending unit in a 1996 Chevy Camaro?

230.3fh


Where is the fuel tank sending unit on a 1986 Camaro?

In the fuel tank.


Where is the Coolant temperature sending unit located on a 1997 camaro 3.8l?

The 1997 Chevrolet Camaro 3.8 liter engine coolant temperature sending unit can be found on the front of the engine. The coolant temperature sending unit will be approximately 3 inches above the thermostat housing.


Where is the fuel sending unit located in a 1982 Chevrolet Camaro?

It is in the gas tank.


Where do you find the fuel sending unit on a 1994 Camaro?

It is located in the gas tank.


Where is the oil sending sensor on a 1994 camaro?

It is right next to the oil filter


1995 Camaro shakes when drived over 45 mph?

on my 94 3.4 maro i had the same problem so i went a head and checked the pistons and the cylinder head for cracks but it turned out to be the camshaft it was all worn so i got that changed oh and i changed the timing chain to. To complete it i changed the valve springs and did a complete tune up. Trust me its worth it you wont have that problem no more and your car wont start shaking but it was about 400$ well good look on your camaro


Why wont my 1988 camaro 2.8L not hold oil pressure?

Bad Oil sending unit.


What causes your gas gauge to not work in a 2000 camaro?

A bad sending unit in the gas tank.