No, bulb needs replacing.
Your selector should be in the neutral position. Select 4WD H, and move selector into drive. Your light should stay on. If the light is turning off, you may have a problem with the actuator or hubs. Sometimes going from Park to Drive, your 4WD will disengage.
Dome light, defective door switch or wire disconnected. Gear Selector, bulb needs replacing. Airbag light on, problem with the SRS. Not a DIY repair, serious injury can occur. Take it to a pro.
The od light means that the over-drive is off. Pushing the little button on the shifter selector will turn it on (when the dummy light is not on) and off (when the dummy light is lit).
No, it is not. The light is on because the belt needs replacing immediately.
you have to acess it from inside the trunk drive safe
Not charging. Poor battery, poor alternator, voltage regulator, slipping drive belt.
How do you reset maint read light on 2010 corolla
my2003 toyota corolla the airbag light is on
The center brake light replacement will require replacing the entire brake light assembly. Remove the wiring harness. Remove the center brake light retaining screws. Reverse the process to install the new center brake light.
HOW TO FIX A PARKING LIGHT ON A 1996 TOYOTA COROLLA
No. It has a unlit reference. The illuminated selector in on the center dash.
over-drive... take it its an auto On the gear selector handle, there is a button. Pushing that button will turn the Over drive off (light is on) or turn it on (light is off). This allows it to leave 3rd gear, and will put less wear on the engine and transmission at a speed of about 45 or higher.