0
The serpentine belt on your 2001 corolla make a sqeeling noise when the engine first start running After running for about five minutes the squeeling noise stops What could be the problem Thanks?
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How long to install a serpentine belt on 2007 Toyota corolla?
About 20 minutes
How long of a drive is it to corolla nc from Pittsburgh pa?
It will take approximately 8 hours and 48 minutes
How do you reset the alarm on a corolla 1993?
To reset the alarm on a Corolla 1993, place they key in the ignition and turn it until it clicks. Keep the key in this position for 10 minutes and then start the car as normal.
What would cause a 2001 Toyota Corolla to stall out when you first accelerate and after choke and sputter for a few minutes?
it may be the maf sensor i got a corolla 2001 too do you have any codes ?this is a old question thought.
How does Serpentine belt 1999 Escort diagram look?
Go to your auto parts store, they will show you in 10 minutes or less.
How do you reset the check enginge light on a 1998 Toyota corolla?
disconnect the negative on the battery cable for 15 minutes and then reconnect.
Why would your 95 Toyota Corolla die after running for 5 minutes then wont strt back up?
Timing Belt?
How to reset alarm for 94 corolla after changing battery?
To reset an alarm for a 94 Corolla after changing the battery, place the key in the ignition and turn it slightly. Let it remain in that position for several minutes before starting the car.
How do you reset the check engine light on a 2007 Toyota Corolla?
Try unhooking your battery cables for a few minutes. That usually works for me.
How do you set the clock on a 2009 Toyota Corolla?
With Corolla stopped(this is for safety) this is how you set the clock on the 2009 Toyoya Corolla All Models. (page 148 in 2009 Corolla Manua)l Step 1 - Display the clock when the vehicle is stopped. Step 2 - Press and hold the display buttin to enter the adjustment mode for the clock. Step 3- Press the display button to adjust the minutes. After adjusting the minutes, wait 5 seconds to allow the minutes to be automatically input. Step 4 - Press the display button to adjust the hours. After adjusting the hours, wait 5 seconds to allow the hours to be automatically input. Happy adjusting 0:-)
How long can a car drive without a serpentine belt?
Not very long if it powers the water pump, -possibly 5-7 minutes before you overheat.
What is the labor to replace a crank sensor on a 1997 Toyota Corolla?
About 15 minutes , it is external need to lift vehicle if your timing belt cover is plastic!
