0
The water pump on my 1994 Chevy Camaro Z28 is loose but will not slide off the camshaft?
Wiki User
∙ 12y ago
did you take out all six bolts?
sometimes they rust to the shaft be carefull i had to brake the shaft to get one off then pull the timing cover to replace the broken gear
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Where is the belt tensioner in a 68 Chevy Camaro?
No such device, back in 68. The alternater has a bracket that will allow it to slide out to tighten the belt.
How do you change the ignition switch on a 1997 Chevy Camaro?
You will need to remove the retaining ring from the top of your 1997 Chevy Camaro ignition switch. The ignition switch will slide out. Remove the wiring harness. Reverse the process to install the new ignition switch.
Why would the rockers slide to the side of the valve stem after adjustment on a 1970 Chevy 350?
they are either too loose or worn out
How do you replace a serpentine belt on a 01 camaro v-6?
You will need to loosen the tensioner pulley. Slide the tensioner pulley to the right and the serpentine belt will become loose. Remove the old serpentine belt and put the new serpentine belt on. Slide the tensioner pulley to the left and tighten it.
Is there any other ways to remove a starter from a 95 Chevy camaro without removing the exhaust?
you do not need to remove the exhaust. with some minor manuevering, it should slide out a bit towards he front of the vehicle.
How do you remove camshaft thrust plate from RB30 motor?
remove the seal and slide it to the side
How do you change and adjust the alternator belt on a 1999 Daewoo Matiz SE?
quite easy it has a slide bracket on alternater slide one way it is loose slide the other way it will tighten. quite easy it has a slide bracket on alternater slide one way it is loose slide the other way it will tighten.
How do you get the camshaft pulley off?
It depends on what you are working on. Some just slide off and some have to be pulled off with a puller.
How do you disassemble a drive chain on a 1996 Chevy 4x4 truck?
Do you mean the timing chain? You'll need to pull everything in front of the timing chain cover, remove the timing chain, remove the bolts that hold the sprockets and slide the sprockets off the camshaft and the crankshaft.
What is the angle at which loose material will not slide down a slope?
90 degrees
What is the definition of a land slide?
Loose soil and rubble moving down a slope.
How do you remove the starter from a 1993 Chevy Camaro?
If your camaro has a manual transmission your starter will be on the passenger side of the of the engine right in front of the transmission and i dont think you need to remove the transmission but there should be twobolts that should be visible from underneath and as soon as you remove them just pull it forward and it should just slide out. After that you just need to remove the power cables and reverse the process. That is how it was on my car and if it is off i apologize. good luck
