Control Module Control Module is located on the firewall just inboard of the master cylinder. Removal & Installation 1. Disconnect the negative battery cable. 2. Remove the instrument cluster panel. 3. Remove the front control module mounting bracket screw. 4. Remove the rear control module mounting bracket screw. 5. Lift the control module and mounting bracket from the instrument panel and detach the control module electrical connectors. 6. The installation is the reverse of the removal.
in the center of the dashboard
The air suspension control module is located behind the instrument panel, on the driver's side 'A' post. The control module is attached to the 'A' post with a single screw and two plastic clips.
find body control module its on that
The power train control module is behind the kick panel on the passenger side floor board.
The body control module, on your 1997 Oldsmobile, is located on the rear suspension. The module is mounted on the passenger side of the rear axle.
Where can I locate the "Lamp Control Module" on a 1994 Buick Park Avenue
1995-1997 Town Car The module is located behind the glove box. Flip the glove box down and locate the air suspension module mounted on the heater core directly in front of you.
The suspension control module (otherwise known as a vehicle dynamics module (VDM)) is located in the trunk underneath the dash of the rear window, almost center, slightly off to the driver side. When servicing this, BE SURE TO TURN THE IGNITION AND THE AIR SUSPENSION SERVICE SWITCH TO THE OFF POSITION. Then you will need to remove the upper trucnk compartment trim panel and lower the module tray. Disconnect the wiring harness jfrom the control module, unsnap the control module from ray clips and remove. Reverse procedure to install.
Check your Control Module Control Module is located on the firewall just inboard of the master cylinder. Removal & Installation 1. Disconnect the negative battery cable. 2. Remove the instrument cluster panel. 3. Remove the front control module mounting bracket screw. 4. Remove the rear control module mounting bracket screw. 5. Lift the control module and mounting bracket from the instrument panel and detach the control module electrical connectors. 6. The installation is the reverse of the removal.
On a 2002 Ford Expedition : In the power distribution box ( which is " live " ) located in the drivers side of the engine compartment : ( maxi fuse 109 is a 50 amp fuse for the air suspension compressor ) ------------------------------------------------------------------------------------------------- Also , in the fuse panel below and to the left of the steering wheel , by the brake pedal ( # 12 is a 15 amp fuse for the air suspension switch ) ( # 20 is a 5 amp fuse for the air suspension module , audio , GEM module , and memory module )
get a new light
The computer module, or ignition control module, is locate on the left inner fender.