0
99 expedition replace rear air suspension compressor does not run is it the rear sensor height or solenoid sensor?
Wiki User
∙ 15y ago
Check your Control Module Control Module is located on the firewall just inboard of the master cylinder. Removal & Installation 1. Disconnect the negative battery cable. 2. Remove the instrument cluster panel. 3. Remove the front control module mounting bracket screw. 4. Remove the rear control module mounting bracket screw. 5. Lift the control module and mounting bracket from the instrument panel and detach the control module electrical connectors. 6. The installation is the reverse of the removal.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Where is the suspension compressor relay for a Mercedes s430 located?
how to replace air suspension compressor
How do you replace the check valve for the air suspension on a mark 8?
The Mark 8 does not have a check-valve in the air suspension system. Each air spring has a solenoid valve, which controls fill and vent of the spring. There is a fifth in the suspension compressor itself, which controls venting the system. I discovered that the seat for vent valve was corroded in my compressor, which would then leak when the system was trying to fill. This resulted in the compressor running, but the car lowering. I was able to clean the seat up for a temporary repair, but ultimately replaced the compressor.
How do you change a ac compressor on a 2004 ford expedition?
Do y need puller to replace ac clutch on compressor. 2004 expition
Do you replace Hydraulic Line To Suspension Pump when replacing compressor?
no you do not yo may have to bleed out all the air
Can you remove the air suspension from a 2000 ford expedition and replace it with stock shocks?
go to strutmasters.com
If you have a 98 expedition you hear the compressor on and even the loss of some air but my rear end does not rise What should you check now?
You need to replace your air suspension. The parts are only $100 per side. They say you need to replace them about every 100,00 miles. It took me and a friend about an hour and a half to replace them, Very easy. They also recommend you replace your air compressor at the same time. www. strutmasters.com If your looking to get away from all the air problems all together, I suggest checking out their conversion kits. I bought one for my Expedition and love the ride!
How do you replace the air suspension compressor?
You have to gain access thru the passenger side wheel well, remove the liner and look towards the front and you will see the small compressor.
How to replace Air ride suspension compressor for 1998 Lincoln town car?
locate compressor on left inner fender under air filter box which will need to be removed unplug wire at compressor there are three nuts holding the compressor in. You get at them from under the car. lift out old compressor.
How much does it cost to replace a shift solenoid in a ford expedition?
The part is $46 from Ford dealer plus cost of labor unless you do it yourself.
How do you repair the air suspension for a 2001 Lincoln?
I had a friend replace the air suspension compressor pump with a used one that I bought on ebay. The air compressor pump is located under the windshied washer fluid container. You have to take a cover plate off to get to it or even see it. We discovered that the top of the air suspension compressor pump, where the air hose goes into it, screws off with a crescent wrench. So we just left the hose attached to the top of the pump and replaced the body of the the pump. I have no idea how you would just replace the hose.
How do you replace a shift solenoid on an 97 expedition?
First you drain the trans by removing the pan, then you remove the trans oil filter, the solenoids are clearly visible after that. All that is left is to remove the retaining bolt that holds the solenoid to the valve body. Install new solenoid in reverse order.
What would cause the air suspension on a 2003 Lincoln navigator not to work?
there are several causes to the air pump. the first and most obvious is the air pump (compressor) itself. if you do not hear the compressor pumping air or if you do not feel the slight vibration of the compressor when you put your car into drive, then it's probably the compressor that has gone bad. if the compressor is coming on and you do not hear any air leaking, then your problem could be the height adjuster, located on the suspension bags themselves. Bronconvict: another possibility includes the compressor relay switch. This switch controlls the power to the air bag suspension compressor. This switch is known for burning out when the suspension compressor is working too hard. This can also be caused by a bad/corroded GEM module (due to notorious winshield leak). i had to replace "height sensor" on driver side . part was $200.
