Want this question answered?
torque settings for mains,big ends and cylinder head Opel Corsa 1.7diesel 2000
2002 opel corsa 1.7 turbo diesel cylinderhead torque settings
what are the torque settings for opel corsa b 13 ne
Bigends and main torque and cylinder head torque Opel corsa d 2009 1.4i 16v CZF729
I would not recommend it. The bolts are stretched during the torque procedure.
Main bearing caps==Oil the bolts and tighten to 88Nm. Con rod caps (big end)Use new bolts,torque to 25Nm + 100 degrees + 15 degrees. Flywheel bolts 30Nm + 45 to 60 degrees. Need angle guage for two previous items,or can mark out a card disc. Oil baffle to cylinder block 26Nm. Oil intake pipe to block(new O-ring)19Nm. Sump bolts 10Nm.
Torque Setting for what?
what is the torque settings on the big ends and conrods on the opel corsa 1.4 utility
on a corsa life , 53 plate , its a T40 torque drive.
New bolts must be used torque figures are Stage 1. 25 newton metres stage 2. + 60 degrees stage 3. + 60 degrees stage 4. + 60 degrees Tightening sequence 10 6 2 3 7 9 5 1 4 8 front of car this side hope this helps Mike 2
Cylinder head bolts Torgue wrench settings: Stage 1 ................ 25 Nm (18 lbf ft) Stage 2................. Angle-tighten a further 60 degrees Stage 3................. Angle-tighten a further 60 degrees Stage 4................. Angle-tighten a further 60 degrees USE NEW BOLTS
1st stage 26nm 2nd stage 90 degree 3rd stage 90 degree 4th stage 90 degree