how tight do torgue specs need to be after insalling a intake gasket on a 2003 Chevy silverado
30 ft/lbs on a cast iron intake.
18 ft lbs
11 ft lbs
what is the torque specs to a 2002 Chevrolet Malibu 3.1 liter motor. Need head and intake torque specs. and sequence.
intake torque specs 2002 buik century
torque specs 350 Chevy heads65 lbs
If it is a small block V8 with cast iron heads you torque them to 30 ft/lbs.
Head bolts are 65 lb/ft. Look at the link, "Small Block Chevy" at the right for all torque specs.
lower intake is 132 lb's upper intake is 89 lb
45, for an iron intake, 35 for aluminum.
does anyone know the torque for cast iron exhasut on aulm heads ..small Chevy
alero intake manifold torque specs
40 lb/ft Cast iron heads.
The parts store should have the Head Bolt specs...for the intake...You should be able to find a shop manual at your local library -- make copies of the right sections as they are usually only available in the REFERENCE section...good luck :)
You can find them here->http://www.boxwrench.net/specs/chevy_sb.htm
depends on the engine that the truck has in it. check on autozone.com
torque specs for an 89 chevy suburban
torque specs. on chevy sub for a 5.3L intake manifold and tighten sequence NEW ANSWER; step 1 is 44in-Lbs. then step 2 is 89in-lbs. That's it.
70 ft ponds and start in middle and go in circlevisit boxwrench.net/specs/chevy_sb.htm
Iron Intake to Iron Heads - 40ft lbs Aluminum Intake - 25ft lbs