Oh dear, looks as though you will have to take it back to a manufacturer service point. Although you could try and disconnect the battery for 1/2 a day to reset the car's computer.
Start the car push the trip button until you get to engine oil and select reset and you are done.
To reset the light, turn your ignition to on, then press the gas pedal 3 times, then start the car. To reset the light, turn your ignition to on, then press the gas pedal 4 times then you will hear a beep, then start the car.
to reset press and hold the odo reset and turn car on (do not start) and continue to hold for 10 seconds. light will go off
what do you reset the cehck engine light patriot manual transmission 2008? thanks for you support.
Push and hold the odometer reset button while at the same time turning the ignitions switch on but do not start the engine. The light will reset after 5-10 seconds.
Push and hold the odometer reset button and then turn the ignition switch to the on position but do not start the engine. After around 5 seconds the light will reset.
To reset the service CCR light on a 1991 Eldorado, disconnect the battery for 10 minutes. Reconnect it and start the car.
it is due a service and the garage can reset the light
To reset the oil change light on a Ford f150 you start by pressing the button on the dashboard. After you press the button on dashboard, it will start to cycle through liquid level checks, such as fuel level. When it gets to the oil, press and hold the reset button.
Turn key to accessory position. Press and hold trip meter reset button. Wait half a second and turn key to on position (not start) continuing to hold trip button. After a few seconds the service light will start flashing. At this point release the trip button, cycle the key and start the engine. The service light should be reset.
Press and hold the odometer reset button in while at the same time turning the ignition switch to the on position. Do not start the engine. After around 5 seconds the light will reset.
With the ignition off, press and hold in the trip reset button, then turn the key to the on position, do not start the car. After about 15 seconds the light should flash. release the reset button and turn the key off . That should reset the light