0
Were do you find out what amps does a Chevy Tahoe take for a cigrate lighter takes?
Wiki User
∙ 11y ago
i have a 2001 Chevy Tahoe 5.3 fuel injected vortex and my cigarette lighter keeps blowing out. i replaced it with 15 amps fuses but it keeps burn it out. i just want to no if that the right amps for this car
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
What kind of antifreeze does a 1997 Chevy Tahoe take?
It takes the green Antifreeze
What kind of engine oil takes a 02 Chevy Tahoe 5.3 v8?
5w-30
How many quarts of oil does a Chevy Tahoe 4.8 engine take?
With the filter it takes 6 quarts.
How many quarts of oil does a Chevy Tahoe 5.3 engine take?
It takes 6 quarts of oil.
Are truck tires size P23570R16 compatible with a truck that takes tire size P22560R16?
Are 235/85r/16 compatible with 1996 Chevy tahoe
Does a 1999 Chevy Tahoe use r134-a refrigerant?
Yes, I have a 97 and it takes R-134 so yours would being that it's newer.
Labor charge to replace a intake manifold gasket on a 99 Chevy Tahoe?
The labor charge to replace and intake manifold gasket, on a 1999 Chevrolet Tahoe, is approximately $180. It takes approximately 2 1/2 hours to replace the gasket.
Which way does the wheel hub nut come off?
which way does the wheel hub nut on a Chevy Tahoe come offTURN IT TO THE LEFT,, TAKES IT OFF. TURN IT TO THE RIGHT, PUTS IT ON.
What could be the problem it takes 4-6 times to try to start a Chevy Tahoe and then you have to spray starter fluid in it to make it start.?
sometimes after a few trys it will start on it's own.
How many quarts of oil for a 1996 Chevrolet Tahoe?
I have a 97 Tahoe and it takes 5 quarts. That should be the same for you.
How do you replace the rear lamp housing for the license plate on a 2003 Chevy Tahoe?
Get under the vehicle and look up into the bumper where the housing is located. Squeeze the tabs and push the housing out of the bumper. It takes about 10 seconds.
Timing marks for 1997 Chevy Tahoe 5.7l?
this site takes to long when we are stressed out i just need timing marks for 5.7l Chevy engine Timing mark is located on the balancer using a timing light aim at the balancer and the straight edge inscribed will show up set at about 6 dgrees before TDC
