It would be found in front of the transmission, inside the bell housing.
how do you connect the hyraulic master cylinder to the clutch slave cylinder on a 2000 chevy S10 pickup 2.2 4.cylinder
Inside bell housing. Transmission has to be removed to gain access to the slave cylinder/throw-out bearing.
The clutch slave cylinder is probably at fault. Replacement is necessary to fix problem. Transmission must be removed to gain access to the slave cylinder.
The slave cylinder on my s10 in on the driver side of the transmision. There are only 2 nuts that have to be removed to take the slave cylinder off. Then u must take out the pins to remove the clutch line.. Hope this helps
Replace the slave cylinder.
the slave cylinder is bolted to the drivers side of the transmissions bellhousing,the reservoir for it is on tne drivers side firewall
The slave cylinder is inside the trans. If you need to replace it you will have to pull the trans out. Its not that bad, its a afternoon though.
You will need to remove the transmission to replace the clutch slave.
How much labor will cost a person in order to install a clutch slave cylinder on a 1998 S10 will depend upon how much labor charges are. It should take a mechanic no longer than 30 minutes in order to install the clutch slave cylinder.
no , cable operated clutch
fix vapor lock on 1998 chevy s10 2.2 liter 4 cylinder
On the bottom rear of the engine near the transmission.